0046-035046 rail head depth gauge ltrg54-checking ......each checking fixture is supplied with an...
TRANSCRIPT
-
Ref: LTRG54 – Checking Fixture TDS – Issue 3 February 2018
Calibration Certificate
Description Rail Head Depth Gauge checking fixture
Part number LT/RG/54CB
PADS Reference 0046/035047
Dimensions (max) 110mm high x 75mm wide x 75mm deep
Rail Head Depth Gauge: Checking Fixture
Technical Data / Product Description
The Rail Head Depth gauge checking fixture is now available for engineers you wish to
periodically check the accuracy of the gauge.
Manufactured from aluminium and stainless steel, the
fixture is used to check the engraved datum line on the slide
arm on the gauge aligns to 20mm position on the engraved
scale. This will verify the accuracy of gauge by utilising the 4
contact points (a, b, and c profile contacts and d the
underside of the slide arm).
Each checking fixture is supplied with an engraved serial
number for traceability and auditing purposes.
This is a very easy and quick process. Simply place the gauge
on the fixture so that points a, b, and c are in contact with
the datum faces on the fixture. Lower the contact arm on to
the top face of the fixture (point d) and visually check that
the datum line on the contact arm aligns to the 20mm
position on the engraved scale on the gauge.
Using the fixture:
General Description:
The fixture is supplied with a calibration certificate.
Provided the fixture is used with care and consideration, the
fixture should only need recalibrating every 5 years.
Calibration / recalibration (every 5 years)
a
d
c
b