06 corrola altis manual - other equipment

7/31/2019 06 Corrola Altis Manual - Other Equipment

http://slidepdf.com/reader/full/06-corrola-altis-manual-other-equipment 1/12



’06 Corolla_U (L/O 0508)

160

To reset the hour: Push the “H” button.To reset the minutes: Push the “M” button.

The key must be in the “ACC” or “ON”position.

If the electrical power source has beendisconnected from the clock, the time dis-play will automatically be set to 1:00.

When the instrument panel lights areturned on, the brightness of the time indi-

cator will be reduced.

CIGARETTE LIGHTER

To use the cigarette lighter, press it in.After it finishes heating up, it automati-cally pops out ready for use.

If the engine is not running, the key mustbe in the “ACC” position.

Do not hold the cigarette lighter pressedin.

Use a Toyota genuine cigarette lighter or

equivalent for replacement.

PORTABLE ASHTRAY

The ashtray can be removed and usedoutside the vehicle. To use the ashtray,raise the lid.

When finished with your cigarette, thor-oughly extinguish it in the ashtray to pre-vent other cigarette butts from catching

fire. After using the ashtray, close the lidcompletely.

To detach the ashtray, raise the lid.

Clock

Cigarette lighter and portable

ashtray




161

CAUTION

To reduce the chance of injury incase of an accident or sudden stopwhile driving, always completely closethe ashtray after use.

Instrument panel

Rear console box

The power outlets are designed forpower supply for car accessories.

The key must be in the “ACC” or “ON”

position for the power outlet to be used.

NOTICE

z To prevent the fuse from being

blown, do not use the electrici ty over the total vehicle capacity of 12V/120W.

z To prevent the battery from beingdischarged, do not use the power

outlets longer than necessary whenthe engine is not running.

z Close the power outlet lids when

the power outlets are not in use. Inserting anything other than an ap- propriate plug that fits the outlet ,

or allowing any liquid to get intothe outlet may cause electrical fail-ure or short circuits.

Power outlets




162

The direction is indicated on the insiderear view mirror.

If the ignition switch was turned off withthe system on, the system will automati-

cally turn back on when the ignition switchis turned on.

To turn on the compass, push and hold

the “ ” switch unti l the display turnson.

To turn off the compass, push and holdthe “ ” switch unti l the display turnsoff.

The compass indicates the directionthat the vehicle is heading. In theabove case, it shows that the vehicle isheading north.

Displays Directions

N

NEE

SE

SSWW

NW

North

NortheastEast

Southeast

SouthSouthwest

West

NorthwestThe compass may not show the correct

direction in the following conditions:

D The vehicle is stopped immediately af-

ter turning.

D The compass does not adjust while thevehicle is stopped.

D The ignition switch is turned off imme-diately after turning.

D The vehicle is on an inclined surface.

D The vehicle is in a place where theearth’s magnetic field is subject to in-terference by artificial magnetic fields

(underground parking, under a steeltower, between buildings, roof parking,near a crossing, near a large vehicle,

etc.).

D The vehicle is magnetized. (There is amagnet or a metal object on or near

the inside rear view mirror.)

D The battery has been disconnected.

If your vehicle is out of the set zone,refer to “CALIBRATING THE COMPASS”below to set the zone number.

If the deviation is small, the compassworks to calibrate the direction automati-

cally while the vehicle is in motion.

For additional precision or for complete

calibrating, see “CALIBRATING THECOMPASS” below.

Compass




163

The compass sensor is on the insiderear view mirror.

NOTICE

Do not put magnets or a metal object

on or near the inside rear view mirror of the vehicle. Doing this may cause

malfunction of the compass sensor.

CALIBRATING THE COMPASS (deviationcalibration)

The direction display on the compassdeviates from the true direction deter-

mined by the earth’s magnetic field. Theangle of deviation varies according to thegeographic position of the vehicle.

To adjust this deviation, stop the vehicle,then push and hold the both personal lightswitches until the zone number appears

on the display. Then push the right sideor left side personal light switch, referringto the following map to select the number

of the zone where the vehicle is.




164

Zone number

After calibration, leaving the system forseveral seconds returns it to the compassmode.

CAUTION

Do not adjust the display while thevehicle is moving. Be sure to adjustthe display only when the vehicle isstopped.

Samoa: 5 Guam: 8 Saipan: 8




165

CALIBRATING THE COMPASS (circlingcalibration)

Sometimes the direction display on thecompass may not change after a turn. To

rectify this, stop the vehicle and push andhold the both personal light switches until“C” appears on the display.

If “C” appears on the display because of a drastic change in the magnetic field,perform circling calibration.

Drive the vehicle in a circle at 8 km/h (5mph) or less. If there is not enough space

to drive in a circle, drive around theblock.

After driving 1 to 3 circ les in the abovemethod, calibration is completed when thedirection is shown on the display.

If calibration cannot be performed becauseof the magnetized vehicle etc., take yourvehicle to Toyota dealer.

Perform circling calibration just afteryou have purchased your Toyota. Andthen always perform circling calibrationafter the battery has been removed, re-placed or disconnected.

D Do not perform circling calibration of

the compass in a place where theearth’s magnetic field is subject to in-terference by artificial magnetic fields

(underground parking, under a steeltower, between buildings, roof parking,near a crossing, near a large vehicle,

etc.).

D During calibration, do not operate elec-tric systems (moon roof, power win-dows, etc.) as they may interfere withthe calibration.

CAUTION

D When doing the circling calibration,be sure to secure a wide space,and watch out for people and ve-hicles in the neighborhood. Do notviolate any local traffic rules whileperforming circling calibration.

D Do not adjust the display while the

vehicle is moving. Be sure to adjustthe display only when the vehicle isstopped.




166

To open the glove box door, pull thelever.

CAUTION

To reduce the chance of injury incase of an accident or a sudden stop,always keep the glove box doorclosed while driving.

Type A

Type B

Type C

To use the box, pull on the handle.

CAUTION

D To reduce the chance of injury incase of an accident or a suddenstop, always keep the auxiliary box closed while driving.

D Do not use the auxiliary box as anashtray.

Glove box Auxiliary boxes




167

CONSOLE BOX

To access the rear console box, pull upthe lock release lever while raising therear console box lid.

UPPER TRAY (on some models)

To access the upper tray, raise the con-sole box lid without touching the lockrelease lever.

CAUTION

To reduce the chance of injury incase of an accident or a sudden stop,always keep the console box closedwhile driving.

Rear console box




168

Front

Rear

The cup holder is designed for holdingcups or drink−cans securely.

Rear: To use the holder, pull it out.

CAUTION

D Do not place anything else otherthan cups or drink−cans in the cupholder, as such items may bethrown about in the compartmentand possibly injure people in thevehicle during sudden braking or inan accident.

D Rear cup holder—To reduce thechance of injury in case of an acci-dent or sudden stop while driving,keep the cup holder closed when itis not in use.

Use a floor mat of the correct size.

If the floor carpet and floor mat have 2

holes, then they are designed for use withlocking clips. Fix the floor mat with lock-

ing clips into the holes in the floor carpet.

Cup holders Floor mat




169

CAUTION

Make sure the floor mat is properlyplaced on the floor carpet. If the floormat slips and interferes with themovement of the pedals during driv-ing, it may cause an accident.




170

06 corrola altis manual - other equipment

Documents