1. 2. 3. 4. 5....6. install the kc hilites led light using the mounting hardware attached to the...

1
Locate and remove the T15 Torx bolt holding the front fender liner to the wheel well. 1. Gently pull back the fender liner and remove the 2pcs 10mm bolts from the plastic shield. 2. Now unplug the factory harness from the fog light. 3. To remove the fog light, you will need to squeeze and push the (3) circular locking tabs as shown in the image to the right (circled). 4. Unclip the (3) flat tabs and remove the 10mm bolt as shown in the image to the right in order for the front trim ring to be removed (arrows). 5. Install the KC HiLiTES fog light brackets with the supplied carriage bolts, flat washers, lock washers, nuts and nylon spacer as shown in the image. 6. Install the KC HiLiTES LED light using the mounting hardware attached to the bracket on the light housing. Aim and do a final tightening of all bolts/nuts if necessary. 7. Repeat steps 1-7 for other side of vehicle. 8. Parts Included: 2 x Fog Light Brackets 2 x Nylon Spacers All necessary hardware for installation Tools Needed: 1/2” Socket 10mm Socket T15 Torx Bit 6mm Allen Wrench Socket Wrench Extension 2015-16 CHEVROLET 2500/3500 FOG LIGHT KIT Copyright 2016 KC HiLiTES, Inc. Rev 11222016 - KC3265DX

Upload: others

Post on 24-Jan-2020

0 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: 1. 2. 3. 4. 5....6. Install the KC HiLiTES LED light using the mounting hardware attached to the bracket on the light housing. Aim and do a final tightening of all bolts/nuts if necessary

Locate and remove the T15 Torx bolt holding the front fender liner to the wheel well.1.Gently pull back the fender liner and remove the 2pcs 10mm bolts from the plastic shield.2.Now unplug the factory harness from the fog light.3.

To remove the fog light, you will need to squeeze and push the (3) circular locking tabs as shown in the image to the right (circled).

4.

Unclip the (3) flat tabs and remove the 10mm bolt as shown in the image to the right in order for the front trim ring to be removed (arrows).

5.

Install the KC HiLiTES fog light brackets with the supplied carriage bolts, flat washers, lock washers, nuts and nylon spacer as shown in the image.

6.

Install the KC HiLiTES LED light using the mounting hardware attached to the bracket on the light housing. Aim and do a final tightening of all bolts/nuts if necessary.

7.

Repeat steps 1-7 for other side of vehicle.8.

Parts Included:2 x Fog Light Brackets2 x Nylon SpacersAll necessary hardware for installation

Tools Needed:1/2” Socket10mm SocketT15 Torx Bit6mm Allen WrenchSocket Wrench Extension

2015-16 CHEVROLET 2500/3500 FOG LIGHT KIT

Copyright 2016 KC HiLiTES, Inc.Rev 11222016 - KC3265DX