170727 mini-manual 1.7 conv de68-04426a-01...

2
38% 12 Set Clock -Touch settings pad, dial to select clock set, dial time of day, press dial to enter. Alternately touch each fuction pad and dial time, power level or selection for the selected fuction. 6KRUWHG *DV VHQVRU 2SHQ 7KHUPLVWRU Touch Cancel/Off after each function test to clear that function. • CN101 - Primary SMPS Connector. • CN201 - Inrush Relay, Main, Turntable & Convection Motor Relay connector. • CN202 - Damper Motor, Vent Relay Connector. • CN203 - Cooktop Light Source Connector. • CN204 - Cooktop Light Relay Connector. • CN301 - Cooking Sensor Connector. • CN302 - Door & Hood Sensing Connector. • CN601 - Encoder Connector. • CN702 - Display Module Connector. • CN703 - Bluetooth Module Connector. • CN901 - Filter Remind LED Connector Repeat procedure for each function to exercise each pad Control and display should respond to each entry. Display should revert to Time-Of-Day after each Cancel/Off Refer results to Diagnostic Flow Chart .H\SDQHO VKRUWHG FRQWLQXRXVO\ IRU VHFRQGV 2SHQ *DV VHQVRU SENSOR ERROR DQG HARDWARE FAULT DETECTION VLJQDO F\FOHV VHFRQG RQ VHFRQG RII ORXGO\ LQ XSSHU FRQGLWLRQ .(<3$' 6+257(' 6(59,&( 0$< %( 1(('(' 23(1 67($0 6(1625 6(59,&( 0$< %( 1(('(' 6+257(' 67($0 6(1625 6(59,&( 0$< %( 1(('(' 23(1 7+(50$/ 6(1625 6(59,&( 0$< %( 1(('(' 6+257(' 7+(50$/ 6(1625 6(59,&( 0$< %( 1(('(' '$03(5 678&. 6(59,&( 0$< %( 1(('(' $%1250$/ +,*+ 7(03 6(59,&( 0$< %( 1(('(' 6KRUW 7KHUPLVWRU 2Q &RQYHFWLRQ IHDWXUHG LI RYHQ WHPSHUDWXUH LV RYHU WKH VHW WHPSHUDWXUH IRU PLQXWHV 6WXFN 'DPSHU 3RSFRUQ %HYHUDJH &RRN 5HKHDW 'HIURVW :HLJKW7LPH 7LPHU 2Q2II 6WHDP &OHDQ 7XUQWDEOH 2Q2II &KHI &RQQHFW 2Q2II 6HWWLQJV 0XWH 2Q2II 5HVHW )LOWHU 9HQW )DQ 6XUIDFH /LJKW 6WDUW3DXVH &DQFHO2II $GG VHF &RRN 7LPH &RQYHFWLRQ %DNH &RQYHFWLRQ 5RDVW &RQYHFWLRQ 6SHHG &RRN 3RZHU /HYHO (160/60°C)(320/140°F)

Upload: others

Post on 26-Sep-2020

1 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: 170727 Mini-Manual 1.7 Conv DE68-04426A-01 Front+Backmembers.msaworld.com/wp-content/uploads/sites/3/...MWO Power 950 Watts Power Source 120 VAC, 60 Hz. Line Current 14.6 Amps. (1750Watts)

Set Clock -Touch settings pad, dial to select clock set, dial time of day, press dial to enter. Alternately touch each fuction pad and dial time, power level or selection for the selected fuction. Touch Cancel/Off after each function test to clear that function.

• CN101 - Primary SMPS Connector.• CN201 - Inrush Relay, Main, Turntable

& Convection Motor Relay connector.• CN202 - Damper Motor, Vent Relay Connector.• CN203 - Cooktop Light Source Connector.• CN204 - Cooktop Light Relay Connector.• CN301 - Cooking Sensor Connector.• CN302 - Door & Hood Sensing Connector.• CN601 - Encoder Connector.• CN702 - Display Module Connector.• CN703 - Bluetooth Module Connector.• CN901 - Filter Remind LED Connector

Repeat procedure for each function to exercise each padControl and display should respond to each entry.Display should revert to Time-Of-Day after each Cancel/OffRefer results to Diagnostic Flow Chart

SENSOR ERROR HARDWARE FAULT DETECTION

(160/60°C)(320/140°F)

Page 2: 170727 Mini-Manual 1.7 Conv DE68-04426A-01 Front+Backmembers.msaworld.com/wp-content/uploads/sites/3/...MWO Power 950 Watts Power Source 120 VAC, 60 Hz. Line Current 14.6 Amps. (1750Watts)

950 WattsMWO PowerPower Source 120 VAC, 60 Hz.Line Current 14.6 Amps. (1750Watts)

Working Voltage 108-132 VAC.

2. Place beaker in center of the cooking tray.

Over Current Protection 20 Amps ** Requires 120 Volt, 20 Amp. parallel, grounded separate circuit.

ELECTRICAL

1. Disconnect power and open the door.2. Remove the hinge clip.3. Remove the Door.

The Oven Thermal Cutout is located on the Exhaustduct that is put on the top side of the Oven Cavitywith a temperature rating of 356℉ (180℃).The cutout is tightly held to the top of the Exhaustduct by two screws.

Single pole thermostat mounted on the heatercasing that is located on the left side of the ovencavity. Contacts open at approx. 302℉ (150℃).

1. Disconnect power and remove bottom platescrews(7).

2. Disconnect the cooktop lamp wire and removethe guide air bottom screw(1).

3. Disconnect the turntable motor wire.4. Remove the turntable motor screw(1) and pull

the turntable motor.

HEATER THERMOSTAT

Single pole thermostat mounted on themagnetron that is located on the right sideof the oven cavity.Contacts open at approx. 320℉.

MAGNETRON THERMOSTAT