2 POINT GUN RESTModel No. 65808

PLEASE READY CAREFULLY BEFORE USE

IMPORTANT For your protection, please read these warnings, precautions and safety/operating instructions completely before operating this product. Follow these instructions closely and keep this manual for future reference.

FAILURE TO FOLLOw ThESE INSTRUCTIONS AND wARNINgS COULD RESULT IN PROPERTY DAMAgE, INjURY OR EvEN DEATh. PRIMOS® ASSUMES NO LIABILITY FOR UNSAFE USE.

IMPORTANT SAFETY INFORMATION:

- THIS PRODUCT IS INTENDED TO INCREASE THE BALANCE, SUPPORT AND STABILITY OF THE FIREARM WHILE SHOOTING, IT IS NOT MEANT TO HOLD A FIREARM UNATTENDED. ALWAYS HAVE A SECURE HOLD ON THE FIREARM WHILE USING THE 2 POINT GUN REST. - Only use this product as intended and shown in these instructions. - This product is intended for use by adults or under strict supervision of an adult. - Firearms are inherently dangerous – always follow the rules of gun safety when using this product. - This product is NOT intended to absorb recoil from the firearm! USER MUST HOLD FIREARM SECURELY WHILE SHOOTING – hold and brace the firearm in the same manner as when shooting without the 2 Point Gun Rest. - It is strongly recommended to follow these instructions and practice with the product before using with a firearm or taking into the field. - When using this product in a blind/enclosure, the end of the firearm barrel should always be pointed outside and in a safe direction. Also, to protect your hearing, never fire a firearm with the end of the barrel inside the enclosure. ONE YEAR SERvICE gUARANTEEPrimos’ limited warranty covers any defects in materials and/or workmanship for the period of 1 year from the date of purchase. Warranty applies to the original purchaser and is not transferable. Should the product be proven to Primos to be defective, we shall decide to repair or replace the product at our discretion. Damages that result from the misuse or abuse of the product are not covered. Any claims must be submitted to the customer service department using the contact information below. All returned products must be accompanied by the original dated receipt and proof of purchase to be considered for repair or replacement.

DISCLAIMERSThe illustrations in this manual are for instructional purposes only and may not represent the actual product exactly.

MODIFICATION wARNINg

Changes or modifications not expressly approved in these instructions could void warranty of this equipment.

Printed in China

DEPLOYMENT AND USE INSTRUCTIONSIMPORTANT NOTE: Opening/Closing or adjusting the 2 Point Gun Rest improperly can cause damage to the product.

The 2 Point Gun Rest is Fully Assembled in the package and ready for use! Please follow these steps to setup and use:

1. Install on top of a safe and stable tripod using standard 3/8”-16 threaded insert on the bottom of the 2 Point Gun Rest. For use with 1/4”-20 stud, screw the included adapter onto the base of the rest with a flat head screwdriver.

2. Rotate front and rear shooting rest yokes into the upright position by simply pulling up. 3. Balance unloaded firearm over 2 Point Gun Rest to help determine the desired height and lateral position of the shooting rest yokes. a. Adjust the yokes up and down to balance the firearm correctly When initially setup, the firearm should always rest parallel to the ground. Also, you can adjust up and down for extended magazine clearance. (see Figure 3A) b. Adjust the yokes laterally to fit different lengths/elements of firearms. Make sure to unlock the lever before trying to slide. (see Figure 3B) 4. Check and insure the Tilt Friction Knob in the center of the 2 Point Gun Rest is tight and has enough friction to hold the firearm horizontal when it is set on top (see Figure 4). THIS PRODUCT IS DESIGNED TO BE LIGHTWEIGHT AND HOLD THE WEIGHT OF A STANDARD FIREARM – 10lbs or less. Do NOT use extra heavy firearms over 10lbs and do NOT use to support body weight while aiming or shooting!

5. Only after confirming the tripod is stable, place the forearm of the unloaded firearm on the front shooting rest yoke and place the back yoke on the back of the gunstock.

WARNING: Extreme care must be taken at all times when a firearm is placed on the 2 Point Gun Rest. Insure proper balance and stability at all times. We do not recommend placing the firearm barrel directly on the yoke.

WARNING: After setup is complete, become familiar with the stability of the rest. Know the operations of the rest and the limitations before you place a loaded firearm on it.

WARNING: THIS PRODUCT IS INTENDED TO INCREASE THE BALANCE, SUPPORT AND STABILITY OF THE FIREARM WHILE SHOOTING, IT IS NOT MEANT TO HOLD A FIREARM UNATTENDED. ALWAYS HAVE A SECURE HOLD ON THE FIREARM WHILE SETTING ON THE 2 POINT GUN REST.

COLLAPSINg ThE 2 POINT gUN REST1. Depress locks and fold the yokes flat (see Figure 6).

2. You may need to unlock and slide the yokes laterally so they have room to collapse completely (see Figure 7).