2004-2005 suzuki gsxr600/750 - power commander · 2004-2005 suzuki gsxr600/750 installation...

3
6-03 www.powercommander.com 04-05 Suzuki GSXR600/750 - PCIII USB - 1 2004-2005 Suzuki GSXR600/750 Installation Instructions Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 Parts List 1 Ignition module 1 Installation Guide 2 Velcro ® Strip 1 Alcohol Swab You can also download the Power Commander software and latest maps from our web site at: www.powercommander.com The ignition MUST be turned OFF before installation! This module is intended to be used in conjunction with Power Commander 316-410 PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION Before this module can be used the Power Commander must first be updated. (see included instructions)

Upload: hathu

Post on 17-Jun-2018

229 views

Category:

Documents


0 download

TRANSCRIPT

6-03 www.powercommander.com 04-05 Suzuki GSXR600/750 - PCIII USB - 1

2004-2005 Suzuki GSXR600/750Installation Instructions

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993

Parts List

1 Ignition module1 Installation Guide2 Velcro® Strip1 Alcohol Swab

You can also download the Power Commander software and latest maps from our web site at:www.powercommander.com

The ignition MUST be turned OFF before installation!This module is intended to be used in conjunctionwith Power Commander 316-410

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Before this module can be used the Power Commander must first be updated.

(see included instructions)

1 Remove the main seat.

2 Lift the front of the fuel tank up.

3 Remove the air box.

4 Place the ignition module next to thePCIII and route the harness towardsthe front of the bike.

5 Disconnect the stock wiring harnessfrom the coil sticks (Fig. A).

6 Connect the ignition module connec-tors in-line of the stock wiring harnessand coil sticks (Fig. B).

Ignition module colors:

ORANGE - Cylinder #1

YELLOW - Cylinder #2

GREEN - Cylinder #3

BLUE - Cylinder #4

7 Locate the crank pickup coil connec-tor (Fig. C). This connector is aWHITE 2 pin connector with a BLUEand aGREEN wire.

Fig.

AFi

g. B

Fig.

C

6-03 www.powercommander.com 04-05 Suzuki GSXR600/750 - PCIII USB - 2

Unplug from coil sticks

Unplug crank connector

8 Connect the WHITE connectors fromthe ignition module in-line of thestock crank pickup sensor connectors(Fig. D).

9 Attach the ground wire from the igni-tion module to the negative side of thebattery (Fig. E).

10 Install the ignition module in the tailsection of the bike. It can be attachedto the top of the PCIII if necessary byusing the supplied velcro.

11 Plug the white 10 pin connector fromthe ignition module into the expansionport of the PCIII. If you are using aquickshifter then unplug the quick-shifter from the PCIII and connect tothe expansion port of the igntionmodule harness.

Fig.

DFi

g. E

Fig

F

6-03 www.powercommander.com 04-05 Suzuki GSXR600/750 - PCIII USB - 3

Ground wire from PCIII

Ground wire

Quickshifterconnection

Module connectors

Stock connectors