2010-09-17 bottom insulation plate top insulation plate hot nozzle a plate cavity insert core insert...
TRANSCRIPT
2010-09-17
Bottom insulation plate
Top insulation plate
Hot nozzle
A plate
Cavity insert
Core insertLifting device
B plate
Ejector plate
Bottom plate
Support pillar
Ejector pin
Slider
Lifter
Top plate
Ejector return plate
Hot runner plate
Support plate
2010-09-17
2010-09-17
2010-09-17
Hydraulic cylinder
Hydraulic cylinder
2010-09-17
※Because the big slider construct is very complex, so the slider moving must slow by the hydraulic cylinder, otherwise the slider will be damaged easy.因为结构复杂，大行位在油缸推动的过程中速度一定要慢 ,否则行位容易损坏 .
2010-09-17
※The base of big slider is closed and the yellow inner slider is open before close the mold like the bottom picture show , because the yellow inner slider close by the angle pin of cavity, before the first of close the mold you must insure the big slider at such state.合模前大行位座必须在关闭的位置，黄色内行位必须是打开的状态如下图所示 ,因为黄色行位需要通过前模斜导柱闭合 , 首次合模前必须确保大行位处于这样的状态 .
Angle pins斜导柱
2010-09-17
2010-09-17
Safety device
Slider
Lifter
Bottom insulation plate
Bottom plateEject return plate
Eject plate
Support pillarEjector pinSpace block
B plate
Lifting device
Core insert
Cavity insertA plate
Hot runner plateHot nozzle
Top plate
Topinsulation plate
2010-09-17
Safety device
Adjusting plate
Wedge
Cavity insert
2010-09-17
Hydraulic cylinder
Adjusting plate
Press block
SliderCore insert