8/3/2019 6100 Hot Melt

1/1

Important Notice - Before utilizing the product the user should determine the suitability of the product for its intended use. The userassumes all risks and liability in connection with such use. 3M'S WRITTEN WARRANTY FOR THE PRODUCT IS MADE IN LIEU OF ALLOTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OFMERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The user's exclusive remedy for breach of 3M's written warranty shallbe the repair or replacement of such quantity of product which is proven to be defective. In no case shall 3M be liable for any special,incidental, or consequential damages based upon breach of warranty, breach of contract, negligence, strict liability or any other legal theory.

3M Telecom Systems Division

6801 River Place Blvd.Austin, TX 78726-9000800/426-8688

Printed in USA 3M 1995 78-8097-4212-1

Printed on 50% recycled paperwith 10% post-consumer

Mounting Jacketed Mounting 900 m Buffer

1. Load connector into holder and place in Hot Melt Oven. 1. Load connector into holder and place in Hot Melt Oven.

(Heat for no more than ten minutes). (Heat for no more than ten minutes).

2. Slide boot onto cable. 2. Slide boot and strain relief tube onto cable.

3. Cut and remove 7/8" (22 mm) of jacket. 3. Strip off 3/4" (19 mm) of buffer.

4. Strip fiber with modified No-Nik tool to leave 4. Clean with isopropyl alcohol** and lint-free cloth.1/8" (3 mm) buffer.

5. Clean with isopropyl alcohol** and lint-free cloth. 5. Remove connector and holder from oven.

6. Cut Kevlar strands to 3/16" (5 mm) length. 6. Insert fiber and strain relief tube into connector.

7. Remove connector and holder from oven. 7. Cool in rack for 2 3 minutes.

8. Insert fiber and Kevlar fibers straight intoconnector.

9. Cool in rack for 2 3 minutes.

6100 Hot Melt ST* Bayonet ConnectorQuick Instructions

Polishing

1. Remove connector and holder, score fiber with flat carbide blade, pull fiber straight up to detach, shorten by handpolishing with polishing film if necessary.

2. Perform 1-step polish using soft rubber pad to remove all adhesive.

3. Clean connector and inspect.

Note: For complete details on connector terminating, refer to the instruction manual Hot Melt ST* Bayonet and

ST* Push-Pull Connector.

ST* is a trademark of AT&TKevlar is a trademark of E.I. duPont de Nemours & Co.

**Note: Carefully follow safety, health and environmental information on container label or Material Safety DataSheet for isopropyl alcohol.