8-1 copyright © 2003 by john wiley & sons, inc. chapter 8 switch-mode dc- sinusoidal ac...
TRANSCRIPT
8-1
Chapter 8
Switch-Mode DC-AC Inverters
• converters for ac motor drives and uninterruptible power supplies
8-2
Switch-Mode DC-AC Inverter
• Block diagram of a motor drive where the power flow is unidirectional
8-3
Switch-Mode DC-AC Inverter
• Block diagram of a motor drive where the power flow can be bi-directional
8-4
Switch-Mode DC-AC Inverter
• Four quadrants of operation
8-5
One Leg of a Switch-Mode DC-AC Inverter
• The mid-point shown is fictitious
8-6
Synthesis of a Sinusoidal Output by PWM
8-7
Details of a Switching Time Period
• Control voltage can be assumed constant during a switching time-period
8-8
Harmonics in the DC-AC Inverter Output Voltage
• Harmonics appear around the carrier frequency and its multiples
8-9
Harmonics due to Over-modulation
• These are harmonics of the fundamental frequency
8-10
Output voltage Fundamental as a Function of the Modulation Index
• Shows the linear and the over-modulation regions; square-wave operation in the limit
8-11
Square-Wave Mode of Operation
• Harmonics are of the fundamental frequency
8-12
Half-Bridge Inverter
• Capacitors provide the mid-point
8-13
Single-Phase Full-Bridge DC-AC Inverter
• Consists of two inverter legs
8-14
PWM to Synthesize Sinusoidal Output
• The dotted curve is the desired output; also the fundamental frequency
8-15
Analysis assuming Fictitious Filters
• Small fictitious filters eliminate the switching-frequency related ripple
8-16
DC-Side Current
• Bi-Polar Voltage switching
8-17
Output Waveforms: Uni-polar Voltage
Switching
• Harmonic components around the switching frequency are absent
8-18
DC-Side Current in a Single-Phase Inverter
• Uni-polar voltage switching
8-19
Sinusoidal Synthesis by Voltage Shift
• Phase shift allows voltage cancellation to synthesize a 1-Phase sinusoidal output
8-20
Single-Phase Inverter
• Analysis at the fundamental frequency
8-21
Square-Wave and PWM Operation
• PWM results in much smaller ripple current
8-22
Push-Pull Inverter
• Low Voltage to higher output using square-wave operation
8-23
Three-Phase Inverter
• Three inverter legs; capacitor mid-point is fictitious
8-24
Three-Phase PWM
Waveforms
8-25
Three-Phase Inverter Harmonics
8-26
Three-Phase Inverter Output
• Linear and over-modulation ranges
8-27
Three-Phase Inverter: Square-Wave Mode
• Harmonics are of the fundamental frequency
8-28
Three-Phase Inverter: Fundamental Frequency
• Analysis at the fundamental frequency can be done using phasors
8-29
Square-Wave and PWM Operation
• PWM results in much smaller ripple current
8-30
DC-Side Current in a Three-Phase Inverter
• The current consists of a dc component and the switching-frequency related harmonics
8-31
Square-Wave Operation
• devices conducting are indicated
8-32
PWM Operation
• devices conducting are indicated
8-33
Short-Circuit States in PWM Operation
• top group or the bottom group results in short circuiting three terminals
8-34
Effect of Blanking Time
• Results in nonlinearity
8-35
Effect of Blanking Time
• Voltage jump when the current reverses direction
8-36
Effect of Blanking Time
• Effect on the output voltage
8-37
Programmed Harmonic Elimination
• Angles based on the desired output
8-38
Tolerance-Band Current Control
• Results in a variable frequency operation
8-39
Fixed-Frequency Operation
• Better control is possible using dq analysis
8-40
Transition from Inverter to Rectifier Mode
• Can analyze based on the fundamental-frequency components
8-41
Summary of DC-AC Inverters
• Functional representation in a block-diagram form