9. thermographic phosphors · m. aldén, a.omrane, m. richter and g. särner, “t hermographic...
TRANSCRIPT
-
9. Thermographic phosphors
• Introduction/Background/Theoryg y• Thermometry methods
– Temporal approach– Spectral approach– Calibration– 2D measurements2D measurements
• Applications– Fires– Decomposing material– IC engines– Aero enginesAero engines– Droplets/Sprays
• New trends & applications
M. Aldén, A.Omrane, M. Richter and G. Särner, “Thermographic phosphors for thermometry: A survey of combustion applications”, Progress in Energy and Combustion Science 37, 422-461 (2011)
-
Thermographic phosphors for temperature measurementstemperature measurements
• Industrial and scientific applications.
• Powder(1-10µm), ( µ ),sensitivity from cryogenic to 2000K.y g
• Excitation: UV (light), laser e-beamlaser, e beam.
-
Physical descriptiony p
• Host inorganic material (ceramic) doped with and an activator (rare earth metal)~1 %.and an activator (rare earth metal) 1 %.
• Host material transparent, laser energy b b d b th ti tabsorbed by the activator.
• Through complex interactions in the g pelectronic configuration of the activator and the host temperature will influence thethe host, temperature will influence the spectral and temporal behaviour of the emissionemission
-
Thermometry MethodsThermometry Methods
Lif ti th d D ti• Lifetime method: Decay time.
• Spectral method: Ratio between• Spectral method: Ratio betweenemission lines.
• Emission line shift and linebroadning.
Ab i• Absorption
• Excitation• Excitation
-
Lifetime method: Decay timeLifetime method: Decay time
-
Spectral method: Ratio between emission linesemission lines.
-
Temperature dependent phosphorsSummary of some phosphorsSummary of some phosphors
Särner et al. Meas. Sci Techn. 2008,
-
Calibration proceduresCalibration procedures
-
Calibration proceduresCalibration procedures
YAG: Dy
-
Calibration procedures
-
2D measurements: Spectral methodp
-
2D measurements: Temporal method2D measurements: Temporal method
-
Application 1: Fire studies
-
Experimental setup
•Excitation 266 or 355 nm
•Fuel: Alcohol and Heptane.p
•Detection: Framing Camera.
•Material: LDF and PMMA•Material: LDF and PMMA.
-
Results
-
Application 2. Decomposing materialmaterial
-
Surface temperature of a woodparticle during pyrolysiswoodparticle during pyrolysis
723
)
673
atur
e(K
)
623empe
ratu
623
Tem
0 100 200573
Time(seconds)
-
Application 3: IC engines
-
Results
Intake valves
Exhaust valves
-
Surface measurements in a “production” diesel engine using thermographic phosphors and optical fibers
-
Application 4: Aircraft engineApplication 4: Aircraft engine
-
Experimental arrangement
Segment of flameholder t d ith h h t i l
Nd:Yag laser=266 nm
coated with phosphor material
Lens + Filter 657 nm + PMT + Transimpedance amplifier
-
ResultsResultsTemperature data (lifetime decays) was recorded at the repetition rate of the
it ti l (10 H )excitation laser (10 Hz).
Signals were sampled using a 1 GHz bandwidth oscilloscope (LaCroy).
Power Level (PL) versus time for test cycle B
Temperature data measured for test cycle Bcycle B. cycle B.
-
2D experiments
Investigated SurfaceInvestigated Surface
•Use of YAG:Dy
•Excitation at 355 nm
•Emission at 458 and 493 nm
-
Experimental
Single ShotAveraged Temperature Image
-
Application 5: Droplet/spray
-
One point measurementsOne-point measurements
-
Droplets in acoustic levitationDroplets in acoustic levitation
-
Results: Droplets and Sprays
-
Results: Realistic spray
-
Some further development and application• Simultaneous velocity & temperature measurements
A. Omrane, P. Petersson, M. Aldén and M. A. Linne ”, Simultaneous 2D flow velocity and gas temperature
measurements using thermographic phosphors Appl Phys B Appl Phys B92 99-102 (2008)measurements using thermographic phosphors, Appl. Phys. B. Appl. Phys B92, 99-102 (2008).
• UV and blue emitting phosphors & short decay time;
G Särner, M Richter, M Aldén, “Two-dimensional thermometry using temperature induced line shifts of ZnO:Zn and
ZnO:Ga fluorescence” Opt Lett 33 1327(2008)ZnO:Ga fluorescence”, Opt Lett. 33, 1327(2008)
• Thermometry using multiple scattering
G. Särner, U. Göransson, M. Richter and M. Aldén, Surface temperatures measured through a heated solid porous
material using diffusive scattered laser induced phosphorescence, Submitted to Fire and Materials 2011
More:
Extended temperature range (custom made phosphors);
C. Eckert, C. Pflitsch, B. Atakan, ”Sol-gel deposition of multiply doped thermographic
phosphor coatings (Al2O3:Cr3+, M3+) (M=Dy, Tm) for wide range surface
temperature measurement application”, Prog. in Organic Coatings. 67, 116 (2010)
Flame survivability; Yu et al. Meas. Sci. Techn (2010)
Pressure and gas composition effects; Brubach et al Meas Sci Techn (2007)Pressure and gas composition effects; Brubach et al, Meas. Sci. Techn. (2007)
Laser-induced effects, e.g. heating; Lindén et al. Appl. Phys. B (2009)
Influences from phosphor thickness; Knappe et al. SAE Congress 20100
-
Simultaneous temperature/velocity: LIP + PIVtemperature/velocity: LIP + PIV
-
Laminar flow: Average of 50 imagesimages
-
Turbulent flow: Average of 50 imagesimages
-
Some further development and application• Simultaneous velocity & temperature measurements
A. Omrane, P. Petersson, M. Aldén and M. A. Linne ”, Simultaneous 2D flow velocity and gas temperature
measurements using thermographic phosphors Appl Phys B Appl Phys B92 99-102 (2008)measurements using thermographic phosphors, Appl. Phys. B. Appl. Phys B92, 99-102 (2008).
• UV and blue emitting phosphors & short decay time;
G Särner, M Richter, M Aldén, “Two-dimensional thermometry using temperature induced line shifts of ZnO:Zn and
ZnO:Ga fluorescence” Opt Lett 33 1327(2008)ZnO:Ga fluorescence”, Opt Lett. 33, 1327(2008)
• Thermometry using multiple scattering
G. Särner, U. Göransson, M. Richter and M. Aldén, Surface temperatures measured through a heated solid porous
material using diffusive scattered laser induced phosphorescence, Submitted to Fire and Materials 2011
More:
Extended temperature range (custom made phosphors);
C. Eckert, C. Pflitsch, B. Atakan, ”Sol-gel deposition of multiply doped thermographic
phosphor coatings (Al2O3:Cr3+, M3+) (M=Dy, Tm) for wide range surface
temperature measurement application”, Prog. in Organic Coatings. 67, 116 (2010)
Flame survivability; Yu et al. Meas. Sci. Techn (2010)
Pressure and gas composition effects; Brubach et al Meas Sci Techn (2007)Pressure and gas composition effects; Brubach et al, Meas. Sci. Techn. (2007)
Laser-induced effects, e.g. heating; Lindén et al. Appl. Phys. B (2009)
Influences from phosphor thickness; Knappe et al. SAE Congress 20100
-
New phosphors: Blue, fast and p pvery temperature sensitive!
Ratio calibration for ZnO:Ga and ZnO:Zn
Särner et al. Opt Lett 2008
-
2D temperature measurements in a burning droplet using ZnO:Ga
Särner et al. Opt Lett 2008
-
Some further development and application• Simultaneous velocity & temperature measurements
A. Omrane, P. Petersson, M. Aldén and M. A. Linne ”, Simultaneous 2D flow velocity and gas temperature
measurements using thermographic phosphors Appl Phys B Appl Phys B92 99-102 (2008)measurements using thermographic phosphors, Appl. Phys. B. Appl. Phys B92, 99-102 (2008).
• UV and blue emitting phosphors & short decay time;
G Särner, M Richter, M Aldén, “Two-dimensional thermometry using temperature induced line shifts of ZnO:Zn and
ZnO:Ga fluorescence” Opt Lett 33 1327(2008)ZnO:Ga fluorescence”, Opt Lett. 33, 1327(2008)
• Thermometry using multiple scattering
G. Särner, U. Göransson, M. Richter and M. Aldén, Surface temperatures measured through a heated solid porous
material using diffusive scattered laser induced phosphorescence, Submitted to Fire and Materials 2011
More:
Extended temperature range (custom made phosphors);
C. Eckert, C. Pflitsch, B. Atakan, ”Sol-gel deposition of multiply doped thermographic
phosphor coatings (Al2O3:Cr3+, M3+) (M=Dy, Tm) for wide range surface
temperature measurement application”, Prog. in Organic Coatings. 67, 116 (2010)
Flame survivability; Yu et al. Meas. Sci. Techn (2010)
Pressure and gas composition effects; Brubach et al Meas Sci Techn (2007)Pressure and gas composition effects; Brubach et al, Meas. Sci. Techn. (2007)
Laser-induced effects, e.g. heating; Lindén et al. Appl. Phys. B (2009)
Influences from phosphor thickness; Knappe et al. SAE Congress 20100
-
Phosphorescence thermometry th h lti l tt ithrough multiple scattering
Laser, 266 nm 360LIP using CdWO
4 inside styrofoam
Above
Calorimeter340
350
/ K
AboveBelow (through the styrofoam)
PMT Phosphorpowder 320
330
Tem
pera
ture
/ K
Polystyrene
300
310
PMT
0 1 2 3 4 5 6 7290
Time / min
-
Some further development and application• Simultaneous velocity & temperature measurements
A. Omrane, P. Petersson, M. Aldén and M. A. Linne ”, Simultaneous 2D flow velocity and gas temperature
measurements using thermographic phosphors Appl Phys B Appl Phys B92 99-102 (2008)measurements using thermographic phosphors, Appl. Phys. B. Appl. Phys B92, 99-102 (2008).
• UV and blue emitting phosphors & short decay time;
G Särner, M Richter, M Aldén, “Two-dimensional thermometry using temperature induced line shifts of ZnO:Zn and
ZnO:Ga fluorescence” Opt Lett 33 1327(2008)ZnO:Ga fluorescence”, Opt Lett. 33, 1327(2008)
• Thermometry using multiple scattering
G. Särner, U. Göransson, M. Richter and M. Aldén, Surface temperatures measured through a heated solid porous
material using diffusive scattered laser induced phosphorescence, Submitted to Fire and Materials 2011
More:
Extended temperature range (custom made phosphors);
C. Eckert, C. Pflitsch, B. Atakan, ”Sol-gel deposition of multiply doped thermographic
phosphor coatings (Al2O3:Cr3+, M3+) (M=Dy, Tm) for wide range surface
temperature measurement application”, Prog. in Organic Coatings. 67, 116 (2010)
Flame survivability; Yu et al. Meas. Sci. Techn (2010)
Pressure and gas composition effects; Brubach et al Meas Sci Techn (2007)Pressure and gas composition effects; Brubach et al, Meas. Sci. Techn. (2007)
Laser-induced effects, e.g. heating; Lindén et al. Appl. Phys. B (2009)
Influences from phosphor thickness; Knappe et al. SAE Congress 20100
-
Experimental SetupExperimental Setup – 2 Temperatures from 1 Phosphor Layer
λ/2 plate + pol. beam splitter
Phosphor
Optical Engine
• 10Hz laser rep. rate @ 1200rpm=> 1 shot (= 2 LIP temperatures) / combustion cycle
• 2 Phosphor Thicknesses tested @ 32µm and 59µm
-
Comparison between two different Phosphor thicknesses
-
Further needs
• Nano phosphorsp p
• Phosphors for high temperaturep g p