ac100 to 240vrms class motor control by only … to 240vrms class motor control by only one package...
TRANSCRIPT
© 2016 ROHM Co.,Ltd.
BM63363S-VA /-VC, BM63364S-VA /-VC, BM63763S-VA /-VC, BM63764S-VA /-VC, BM63767S-VA /-VC
Part No. Rating Application
BM63363S-VA / -VC 600V / 10A Low speed switching
fc = to 6kHz BM63364S-VA / -VC 600V / 15A
BM63763S-VA / -VC 600V / 10A
High speed switching fc = to 20kHz BM63764S-VA / -VC 600V / 15A
BM63767A-VA / -VC 600V / 30A
Lineup ラインアップ
アプリケーションに応じたIGBT最適化設計 低速/高速スイッチング用途の2シリーズをラインアップ IGBT optimization design depending on application Lineup in 2 series of the low/high speed switching use
Features
Applications
IGBT、FWD(Free Wheeling Diode)、ブートストラップダイオード、ゲートドライバを1パッケージに搭載 Built-in IGBT, FWD, Bootstrap Diode and Gate Driver
充実の保護回路(短絡電流保護、電源電圧低下保護、熱遮断回路)と保護回路動作時のFAULT信号出力機能 Full Protection Circuits (Short Circuit, Under Voltage, Thermal Shutdown) and Fault Signal Output
白物家電用モータ駆動 Motor Control for White Goods
小容量産業用モータ駆動 Low Power Industrial Motor Control
Application-Specific IGBT Design Optimization アプリケーションに応じたIGBT最適化設計
Block Diagram ブロック図
600V 2nd Generation IGBT-IPM (Intelligent Power Module) 600V第2世代IGBT-IPM (インテリジェントパワーモジュール)
AC100 to 240Vrms Class Motor Control by Only One Package AC100〜240Vrms系モータ制御を1PKGで実現
HVIC (High-side Gate Driver)
・低損失フィールドストップトレンチIGBT
・超低VFファストリカバリダイオード
Bootstrap Diodes ・ブートストラップダイオード電流制限機能
・フローティング電源UVLO ・ファストリカバリダイオード
(保護回路) (電源電圧低下時誤動作防止) (短絡電流保護) (熱遮断)
Protection Circuits UVLO : Under Voltage Lock Out SCP : Short Circuit Protection TSD : Thermal Shut Down
Inverter Part (IGBT and FWD)
Fast Recovery Diodes
Current limiter function for bootstrap diodes
Floating power supply UVLO
Low Loss Field Stop Trench IGBTs
Ultra Low VF Fast Recovery Diodes
24 P
23 U
22 V
21 W
20 NU
19 NV
NW 16 GND 15 CIN
14 FO
13 LVCC
12 LINW
1 1 LINV
10 LINU
9 GND 8 HVCC 7 HINW 6 HINV 5 HINU
4 VBW
3 VBV
2 VBU
High Side Gate Driver
(HVIC)
Low Side Gate Driver
(LVIC)
アプリケーションに応じたIGBTを使用し、高効率駆動を実現
Gen.2 IGBT-IPM for high speed switching drive (fc = to 20kHz) Priority to switching loss
Due to use different characteristic IGBT chip, we can propose suitable item for application
Sw
itchi
ng L
oss
Eof
f (μJ
) ・UVLO, SCP, TSD ・Fault信号出力
Fault signal output
LVIC (Low-side Gate Driver)
Gen.2 IGBT-IPM for low speed switching drive (fc = to 6kHz) Priority to conduction loss
Gen.2 IGBT-IPM for high speed switching drive (fc = to 20kHz) Priority to switching loss
Saturation Voltage VCE (sat) (V)
Gen.1 IGBT-IPM
Gen.1:1st Generation Gen.2:2nd Generation fc:Carrier Frequency (PWM frequency)
Higher Efficiency