advanced construction technology by professor chris gorse, joseph kangwa & ian dickinson –...
TRANSCRIPT
Advanced Construction Technology
By Professor Chris Gorse , Joseph Kangwa & Ian Dickinson – licensed under the Creative Commons Attribution – Non-Commercial – Share Alike License
http://creativecommons.org/licenses/by-nc-sa/2.5/
Skeleton frames: Assembling
Chris Gorse, Joseph Kangwa and Ian Dickinson
These slides should be read in conjunction with Emmitt, S. and Gorse, C. (2010) Barry’s Advanced Construction
of Buildings. Oxford, Blackwell Publishing
Lining the building up
• The building will twist slightly as it is erected. Before casting any concrete any movement in the structure needs to be corrected. Winches are used to pull the building back in line.
Bracing
• Triangulation and solid infill walls are used to hold the structure rigid and resist horizontal loads such as wind.
Column to column – spliced and bolted connection
Universal column
Column prefabricated with end plate
All holes for bolts are accurately predrilled off site
Splice plate bolted to both top and bottom column
End plates welded to the end of each column and bolted together
Steel wedge holds the base in the correct line (position)
Base plate welded to column (plate minimum 12mm thick)
Steel packing shims fix column at correct level
Temporary bund wall (sand)
None shrinkable grout fills void left below plate (liquid grout poured into voids)
Void formed by cardboard or polystyrene cones, which allows +/- 20mm horizontal tolerance is filled with grout
Large washer fixed to bolt to prevent pull out
Column base and holding down bolts
Beam connection using end plates welded to the beam
Universal column
Beam prefabricated with end plate welded to the beam.
End plate
Holes for bolts predrilled in column and beam end plate ensuring accurate fixing