a busy-tone based mac scheme for wireless ad hoc networks using directional antennas

1

A Busy-Tone based MAC Scheme for Wireless Ad Hoc Networks using Directional

Antennas

Hong-Ning Dai, CUHKKam-Wing Ng, CUHK

Min-You Wu, SJTU

GLOBECOM 2007

2

Outline

Introduction Related work Busy-Tone based Directional MAC

(BT-DMAC) Simulation results Conclusion

3

Introduction

Benefit of directional antennas Transmission range Reduced interference Increased spatial reuse

4

Drawback of directional antennas The hidden terminal problem The deafness problem

Introduction

5

Hidden Terminal due to unheard RTS/CTS

D

CB

Data

ACTSDataRTSRTS

Collision!!

6

Introduction (Deafness)

B

C

A

Data RTS

C does not know node A is busy. C keeps transmitting RTSs to node A

7

Related Work Existing MAC protocols using direction

al antennas Directional MAC (DMAC) Dual Busy Tone Multiple Access with Dire

ctional Antennas (DBTMA/DA) Circular-DMAC Tone-based directional MAC (ToneDMAC)

8

Motivation and Goal

Motivation There is no protocol that can completely

solve both the hidden terminals and deafness problems with low overhead

Goal Propose a new MAC protocol to attack th

e hidden terminal problem and the deafness problem

9

Antenna Model

Each node equipped with two interfaces: Directional antenna(Switched beam)

two modes: omni-directional, directional Data transmission

Omni-directional antenna only used to send busy tones notification

10

Busy Tone

Two omnidirectional busy tones: BTt (the transmitting busy tone) BTr (the receiving busy tone)

BTt and BTr is encoded with a beam No. and node ID

11

Neighbor Discovery (NLT)

0

2

3

1

A

B

C

D

E

The NLT of Node A

0 C Yes -

1 B, E Yes -

2 D Yes -

3 - Yes -

beam No. neighbors available duration

10(ms)No

A node will record its neighbors’ info when it overhears any frames (RTS,CTS,data and ACK)

Neighbor Location Table (NLT)

The Finite State Machine of BT-DMAC

IDLEWF_DATA

WF_CTS

S_DATA

T1 T2

T3

T5

T6

T7

T8

T4

T9

Ti (E / A): the transition E: the trigger event A: the action of the transition

T1: data ready AND the beam for the destination available / send RTS and set timerT2: time out AND no CTS / T3: no CTS AND retry < RETRY_LIMIT / retransmit RTS T4: CTS received / BT on, set timerT5: ACK received OR retry >= MAX_RETRY / BT offT6: no ACK AND retry < MAX_RETRY/ retransmissionT7: DATA received / send ACK, BT offT8: time out / BT offT9: RTS received / send CTS, BT on, set timer

13

A scenario

A

BTt(A,0)

0

12

3

0

12

3

D0

12

3

C

0

12

3

F0

12

3

E0

12

3

BTr(B,2)B

14

The time diagram of BT-DMAC

A: Data transmission

B: Data transmission

DATARTS

CTS

ACK

BTt

BTr

A: Busy tone

B: Busy tone

hidden terminal due to unheard RTS/CTS

ACB

D

Deafness

BA

C

DATA

17

Simulation Experiments

SimulatorGloMoSim 2.0 extension with Directional antennas

beamwidth 30 degrees

transmission range 376.78m

distance between each two nodes 360m

packet size 1460 byte

bandwidth 2Mbps

topology Linear

18

Numeric result

0 1 2 3 4

0 1 2 3 4

19

Throughput Comparison 1

r= 2 and p = 0.008 ( trts=tcts=tack=5τ, tdata= 100τ)

20

Throughput Comparison 2

r= 2 and p = 0.008 ( trts=tcts=tack=5τ, tdata= 100τ)

21

Conclusion

We propose BT-DMAC to attack the hidden terminals and deafness problems.

Simulation experiments prove the effectiveness of our proposed protocol.

22

Thank you