a four bike b free-standing rack · 2019. 10. 17. · b. 1 connect base bracket, bottom poles and...

x1 — Top Connector

x2 — Top Pole

x2 — Center pole

x2 — Bottom Pole

x2 — Base Stand

x1 — Base Bracket

x6 — Long Bolts

x8 — Arms

x4 — Short Bolts

x4 — Nuts

x4 — Washers

Tool(s) Required

Parts

Phillips HeadScrewdriver

AdjustableWrench

A

B

C

D

E

F

G

H

I

J

K

Assembly instructions HDRS6800

WARNINGDO NOT EXCEED MAXIMUM TOTAL WEIGHT LIMIT OF 160 LBS (70 Kgs)MAX LOAD PER HOOK: 35 LBS (15.9 kgs) / MAX WEIGHT PER BIKE: 40LBS (18.2 kgs)

C

H

D

A

J

FE

K

I

GFour BikeFree-Standing Rack

B

1Connect base bracket, bottom poles and base standas shown using long bolts.Do not tighten bolts until rack is fully assembled andtubes are properly aligned.Begin from the bottom and work up.

3

5

Connect top polesto center poles,secure with short bolts.Connect top connectorto top poles using long bolts.

4

2Connect center poles to bottom poles,secure with short bolts.

Adjust position of arms beforeplacing bike on stand.

Tighten all boltsusing an adjustablewrench before using.

IMPORTANT / SAFETYIn order to maintain stability always load bikes on the front side �rst.Always load bikes on the bottom �rst and when removing bikes, take from the top �rst.

Delta Cycle Corporation 36 York Avenue, Randolph, MA 02368 USA / 800-474-6615 / www.designbydelta.com

Need help?Email us at service@designbydelta.com& we’ll help solve your issue.

Assembly videoVisit designbydelta.com/downloads

After rack is assembled Arms should be placed at desired height - two perbike (front and rear).

*Front side of rack features the longer section of the base foot