bi-directional solar inverterssolarinverterguru.com/catlouge/luminous--solar pcu-- catalogue...

Post on 07-Mar-2018

216 Views

Category:

Documents

1 Downloads

Preview:

Click to see full reader

TRANSCRIPT

True bi-directional inverters with MPPT charge controller designed especially for solar application. These single & three phase output inverters operate in parallel with the grid utility. Solar electricity is produced when Photons from the sun rays hit Photovoltaic panels, and electrons are generated in the Photovoltaic cells, leading to production of Direct Current (DC).

The electrical energy in form of DC power is used to charge the batteries through a charge controller and also used to cater load through inverter. These PCU's (Power Conditioning Units) are so designed that additional energy generated from Solar PV plants can be exported to the grid.

‹ Bi-directional Solar Inverter with MPPT Charge Controller‹ Inverter with High Speed MOSFET/IGBT and state of the Art DSP Controller‹ High Efficiency and Reliability‹ In-built in output isolation transformer‹ Compliance to IEC standards

‹ Array : Voltage, Current, Power, Temperature‹ Battery : Voltage, Current‹ Grid : Voltage, Current, Power‹ Output: Voltage, Current, Inv. H/S temp. , Power

‹ Under/Over voltage protection for Input, Output, Battery & Array‹ Reverse polarity protection for Array‹ Protection for Output Overload, Short circuit and Over Temperature‹ MCB & Surge protection at Array input Path

MPPT Charger ON/OFF, Battery on Float, Battery on Boost, Battery Low,

Battery Charging/ Discharging, Grid Switch ON, Inverter Switch ON, Grid ON,

Load ON, Inverter ON

Luminous Bi-directional PCU Features:

Display parameter:

Protections:

Indications:

Luminous 1 to 100 KW Inverters

Luminous SOLAR 1000

Luminous Power Technologies Pvt. Ltd.C8 & C9, Community Centre, Janakpuri, New Delhi-110058 (INDIA),Phone: +91-11-40778221/222, Fax: +91-11-25558912Website: www.luminousindia.com

10KW

Noise @ 1 meter (dBA +/-2dBA)Inverter peak efficiency

Output voltage distortion with 100% linear loadOverload at nominal output voltage for 10 minutesOverload at nominal output voltage for 1 minute

Max. Altitude above sea level without de-ratingStandard Compliance Testing

15KW 20KW 25KW 40KW

Nominal Frequency (Hz)Load Power FactorNominal Output Current (A)Voltage regulationVoltage Stability in dynamic condition

Protection degreeDimension (WxDxH in mm)CoolingGalvanic IsolationEnvironment Location Temperature Operating Max. Relative humidity

MPPT VoltageMaximum Output Current (A)Maximum PV power recommended (KW)

Photovoltaic Input

No. of Charge ControllerMPPT Base Charge ControllerSwitching ElementType of ChargerGrid InputInput Supply PhaseNominal Voltage & Voltage Range

Battery VoltageBattery recharge current settingrange from Grid Side

Battery

Battery recharge current settingrange from Array SideInverterSwitching ElementControlNominal Output VoltageOutput Supply PhaseOutput waveform

36A11KW

280-340 V55A 73A

1

92A 107A 128A 147A 165A 183A 367A16.5KW 22KW 27.5KW 33KW

IGBTPWM with MPPT

38.5KW 44KW 49.5KW 55KW 110KW

0-19A 0-28A 0-46A0-37A 0-55A 0-65A

240V

3 Phase 4 Wire415V AC, +10%, -15%

125%

150%

90% 91% 92%<62dBA <72dBA

14A 21A 28A 35A 42A 49A 56A 63A 69A 140A

50 Hz

+/-1%Complies with IEC/EN 62040-3, Class 1

< 2

0.6 lag to 1

1000x900x1500400x700x800 1100x1000x1700500x1000x800IP20 (with open doors)

Forced Air

32 Bit DSP controller415V AC 3Ph+N

3 Phase 4 WireSine wave

IGBT

36A 55A 92A73A 107A 128A 147A 165A 183A 367A

0-74A 0-83A 0-91A 0-182A

IEC 62040 - 1, 2, 3 (For Safety, EMC Class, Testing)

1000 m (For higher altitude complies with IEC/EN 62040 - 3)

Inbuilt isolation transformer at inverter output

Indoor (Free from corrosive gases & conductive dust)0-50°C

OUp to 95% @ 25 C (non-condensing)

System Rating (KW) 35KW30KW

Due to continuous product improvement, the specifications are subject to change without prior notice.

45KW 50KW 100KW

For Home UPS &Inverter Battery Category

Bi-directional

Solar Inverters

1 to 100 KWRange Available

Luminous SOLAR 1000

Ideal solution for commercial buildings,

domestic applications and decentralized power plants

Specifications For Solar Inverters

1KW

Noise @ 1 meter (dBA +/-2dBA)Inverter peak efficiency (Ref. STD IEC 61683)

Output voltage distortion with 100% linear loadOverload at nominal output voltage for 10 minutesOverload at nominal output voltage for 1 minute

Max. Altitude above sea level without de-rating (m)Standard Compliance Testing

2KW 3KW 4KW 10KW

Nominal Frequency (Hz)Power Factor (Within KVA/KW)Nominal Output Current (A)Voltage regulationVoltage Stability in dynamic condition

Protection degree with open doors ColourDimension (WxDxH in mm)CoolingGalvanic IsolationEnvironment Location Temperature Operating Max. Relative humidity @25°C (non-condensing)

MPPT VoltageMaximum Input Current (A)Maximum PV power recommended (KW)

Photovoltaic Input

No. of Charge ControllerMPPT Base Charge ControllerSwitching ElementType of ChargerGrid InputInput Supply PhaseNominal Voltage & Voltage Range

Battery VoltageBattery recharge current setting range from Grid Side

Battery

Battery recharge current setting range from Array SideInverterSwitching ElementControlNominal Output VoltageOutput Supply PhaseOutput waveform

15A*160V – 200V DC

1.1KW*

65V – 90V DC 130V – 160V DC30A* 46A

1

31A 38A 46A 63A2.2KW* 3.3KW 4.4KW 5.5KW

MOSFET/IGBTPWM with MPPT

6.6KW 11KW

9A*

48V

19A* 19A28A 23A 28A 36A

96V 120V

1 Phase 2 Wire230VAC (+15%, -20%)

<58dBA

125%

150%Up to 90% *

<62dBA

4A 9A 13A 17A 22A 26A 44A

50 Hz

+/-2%Complies with IEC/EN 62040-3, Class 1

< 2% *

0.6 lag to 1 (Within KVA and KW rating)

800x600x1100250x620x500* 250x640x600

IP20RAL 7016 Texture

Forced Air

32 Bit DSP controlled*230V AC L-N

1 Phase 2 WireSine wave

MOSFET/IGBT

19A* 39A* 37A56A 46A 56A 74A

IEC62040-1, 2, 3(for Safety, EMC Class, Testing) & IEC 60068-2(1,2,14,30)

1000 m (For higher altitude complies with IEC/EN 62040 - 3)

Inbuilt isolation transformer at inverter output

Indoor (Free from corrosive gases & conductive dust)0-40 °C

Up to 95%

System Rating (KW) 6KW5KW

*Parameters are also available in different specifications.

top related