cm6631 usb install guide for burson conductor sl
Post on 22-Mar-2016
235 Views
Preview:
DESCRIPTION
Â
TRANSCRIPT
CM6631A USB Module Installation Guide for Burson Conductor SL
Remove the 8 screws that held the top
half of the enclosure (3 on each side and
2 on the back).
Remove the 4 screws that held the DAC
PCB.
Then remove the DAC PCB from the unit.
Remove the one bolt that secured the
USB module.
Use your finger to push the USB module
towards the inside of the unit.
One of the pin connector (highlighted in
blue) on the back will be slightly bent,
but that is ok.
Install the new module, align all 4-
connection pins correctly and you are
done.
Reverse the previous steps to restore
the DAC PCB and the unit cover.
top related