dcp1000 installing flash rom

8/20/2019 DCP1000 Installing Flash ROM

http://slidepdf.com/reader/full/dcp1000-installing-flash-rom 1/2

SERVICE UPDATE F1089

Rev. Date: 07/08/02 Rev. #01

Flash ROM Procedure For

DCP1000

Page 1 of 1

Problem: How to install the flash ROM for the DCP1000.

Solutions: Download and install the new flash ROM firmware version.

Installing the Flash ROM

System Requi rements

CPU: Pentium 75 or higherRam: 8 MB or greater (16 MB recommended)

OS: Windows 3.1, 95, 98, 2000

Setup

1. Make sure the equipment’s power cord is unplugged from the wall socket.

2. Make sure your computer is turned off.

3. Connect the IEEE 1284 parallel cable to the machine.

4. Connect the other end of the IEEE 1284 to the printer port of your computer.

5. Power on the computer.

6. Power on the machine while holding down the 5 key.7. On the display screen it will have black boxes on every other LCD segment.

8. The machine is now ready to be flashed.

Installing the New Firmware into the Facsimile Machine

1. Go to Brothersupport.com and download the flash ROM file onto your hard drive for the product you are

working on.

2. A WinZip file will be downloaded onto your hard drive. Unzip the file and three files will be opened on to

your hard drive.

A. DCP10001. 1000_USA.V_D

2. DCP1000 Flash ROM.bat

3. ICEN.EXE

3. Double click on the file DCP1000 Flash ROM.bat folder.

4. A MSDOS Window will appear on your screen

5. The data will now automatically be sent to the machine.

6. The machine will have intermittent beeps and will make musical tones when finished.

7. The machine will go to date and time.

8/20/2019 DCP1000 Installing Flash ROM

http://slidepdf.com/reader/full/dcp1000-installing-flash-rom 2/2

SERVICE UPDATE F1089

Rev. Date: 07/08/02 Rev. #01

Flash ROM Procedure For

DCP1000

Page 2 of 2

8. Press menu 0 2864 within 2 seconds, The LCD of the machine should say maintenance and the lights are

flashing. Note: (If this isn’t the situation, then press the stop key and try again).

9. Press 01, parameter init is shown on the LCD display screen. Then the LCD display returns to the

maintenance mode screen.

10. To verify the customization code, press 74. DCP1000=0001, then press sort button. Then the LCD

display returns to the maintenance mode screen.11. Press 11 to verify the new Rom version was loaded. A report is printed out. On the top right third line

down of the configuration list page you will see REV. followed by a numbers and at the end it has the VER.

Make sure the version matches the one you downloaded. Then the LCD display returns to the maintenance

mode screen.

12. Press 99 to exit out of maintenance mode.