electrical diagram - sawo
Post on 17-Jan-2022
11 Views
Preview:
TRANSCRIPT
Control unit
Control Contactor
Safety Contactor
ElectronicsOn/Off
N L1 N L1L2L3 N N N U V W
L1 N N
N N N U V W
Heating System
Light
3
Light ThermalFuse
TemperatureSensor
Th
.S1
1*50A
L1
N
PE
Ju
nctio
n B
ox
23
0V
IN
50
-lz
3 7
LU
WWR R
N
4
L1 L1
UK042004
WWR RW1
Electrical Diagram
Connecting ASV-3 into a Single Phase power supply
Fig.
The 3 pieces jumper wire with white terminal block used for Single Phase power supply connection.
Connect 1 piece jumper wire to ASV-3 L1, L2, L3 terminals. Connect to L1 terminal from Power Source.
Connect 1 piece jumper wire to ASV-3 Neutral terminals N, N, and N. Connect to Neutral terminal from Power Source.
Connect 1 piece jumper wire to ASV-3 Ground terminals . Connect Ground terminal of ASV-3 to Power Supply Ground.
Fig1ASV 3 Terminals Heater Terminals
TO POWER SUPPLY
TO POWER SUPPLY
TO POWER SUPPLY
Make a wiring connection from ASV-3 Control Panel to Heater Unit. Wires should be properly connected to corresponding letters on both terminal blocks.
Fig.2 Connecting Power Supply to ASV-3 Control Panel
Fig1 Connecting ASV 3 Terminals to Heater Terminals
top related