externally adjustable day&night ir-led vari-focal bullet...
Post on 12-Jul-2020
0 Views
Preview:
TRANSCRIPT
Externally AdjustableDay&Night IR-LED
Vari-focal Bullet Camera
LED 42pcs:
LED 60pcs:
1/3” Sony Super HAD II High-Resolution Color CCD
Lens spec.
Externally Adjustable Focal Length & Focus
Color & B/W Auto Switchable by Photocell
Auto Switching IR-LED Control
- IR LED: 42pcs, 60pcs
Built-in DC Iris level adjustable volume
Built-in Service monitor port
Cable managed bracket
Weatherproof Housing(IP-66)
Power: AC24V/DC12V or DC12V
Standard
Option
42 LEDs2.8~11mm Vari-focal, DC Auto Iris F1.2 Day&Night Lens
3.8~9.5mm F1.29.0~22mm F1.4
6~50mm F1.4
60 LEDs
LED:60pcs
Ø
Ø
LED:42pcs
153
169
144
88102
128.78877.5
1. PROTECTIVE FILM2. FOCUS / ZOOM LEVER BOLT SCREW3. FOCUS / ZOOM RING FIXING SCREW4. FOCUS / ZOOM RING5. DC LEVEL VOLUME SCREW CAP
6. SERVICE VIDEO PORT7. MOUNTING BRACKET8. VIDEO / POWER CABLE 9. SUN-SHIELD
(THE OTHER SIDE SCREWS)
9
8
1 7
6
5
f=3.8~9.5mmf=2.8~11mm
f=6.0~50mm
f=9.0~22mm
4
2
SERVICE VIDEOPORT CAP
3
1. Protective Film Remove this film before operating the camera.
2. Focus / Zoom Lever Bolt Screw To fix the Focus / Zoom Ring to the lens internally.
3. Focus / Zoom Ring Fixing Screw To fix the Focus / Zoom Ring at the desired position after adjusting the lens viewing angle and focus setting as described below.
4. Focus / Zoom Ring These two rings are used to accurately adjust the viewing angle and to sharply focus all objects within the lens field of view.
① Loosen the fixing screws of the Zoom / Focus Ring: To widen the viewing angle turn the “Zoom Ring” to “W” (Wide), to obtain a closer view turn it to “T” (Tele).
② After adjusting the viewing angle adjust the “Focus Ring” to “N” (Near) or “∞” (Far) until the sharpest focus is achieved.
③ Then tighten the fixing screws on each ring.
Parts Description
Be careful not to loosen the Focus / Zoom lever boltscrews which should not be touched in normal use.
It could be caused by water entering to the cameraunless tightened the Focus / Zoom Ring Fixing screw.
6. Service Video Port - As service monitor port, open the service video port cap to connect the service monitor cable and the monitor - Check a picture position through the service monitor and adjust a viewing angle and focus of the camera.
7. Mounting Bracket (Cable Managed Type) - Install the Mounting Bracket at the desired location. Using four supplied screws fix it to wall. - Adjust pan & tilt of the camera with the supplied wrench.
8. Video / Power Cable
9. Sun-Shield - After adjustments, cover the sun-shield on the camera body then tighten it with the sun-shield bolt.
Parts Description
5. DC Level Volume Screw Cap ① Remove the screw cap with the supplied driver. Retain it in a safe place as it must be replaced to protect the camera from water entering. ② Beneath the screw is the DC Level Volume (Port). - For a brighter screen turn the Volume slowly towards “H”(counter- clockwise), for a darker screen turn it towards “L” (clockwise) with a small (+) driver. ③ Screw the Cap back and tighten to protect water entering.
9
SERVICE MONITOR PORT
SERVICE MONITOR CABLE
VIDEO(BNC) OUT
All camera models are supplied with second video output on the camera model. To use this feature along with a service monitor, service monitor cable/connector is reqired.
To avoid fire or shock hazard, must use a UL listed power supply. Check the impedance switch when the screen turns blurred.
10
■ Adjusting Camera View
PAN: Adjusting view directions
ROTATION: Adjusting screen view
TILT: Adjusting view angle
Adjustments
Max. 90% RH
MAX: 620mA/DC12V, 12VA/AC24V
MAX: 1A/DC12V, 18VA/AC24V
ATW
VBS 1.0 Vp-p (75Ω Load)
0Lux (IR LED On)
Internal
More than 48dB (AGC Off)
15.625KHz (H), 50Hz (V)
625 Lines 2:1 Interlace
ITEM
77.5mm (Ø 128.7mm (L)) ×
88mm ( 144mm (L)) Ø ×
-10℃ ~ +50℃-
AC24V/DC12V±10%, DC12V±10%± ±
1/50 sec1/60 sec
550TVL(Color), 580TVL(B/W)
15.734KHz (H), 59.94Hz (V)
525 Lines 2:1 Interlace
752H × 582V (440K pixels)×768H × 494V (380K pixels) ×
1/3" Interline transfer type color CCD (Sony)
Dimensions
Operational Humidity
Operating Temp.
Power Consumption
Power Supply(*)
Lens
Video Output
White Balance
Min. IlluminationSync. System
S/N Ratio
Shutter Speed
Resolution
Scanning Frequency
Scanning System
Effective Pixels
Image Sensor
PALNTSC ITEM
Standard
Option
42 LEDs2.8~11mm Vari-focal, DC Auto Iris F1.2 D/N Lens
3.8~9.5mm F1.29.0~22mm F1.4 6~50mm F1.4
60 LEDs
LED 42 pcs
LED 60 pcs
LED 42 pcs
LED 60 pcs
11
(*) Use regulated & specified power supply.
Externally Adjustable Day & Night IR-LEDVari-focal Bullet Camera
Rev.1
top related