fundamental reservoir properties for high priority ... · • dynamic carbonate evolution captured...

Fundamental Reservoir Properties for High Priority Depositional Environments

Targeted for CO2 Storage

Dustin CrandallUS DOE NETL, Research and Innovation Center

U.S. Department of EnergyNational Energy Technology Laboratory

Mastering the Subsurface Through Technology Innovation, Partnerships and Collaboration:Carbon Storage and Oil and Natural Gas Technologies Review Meeting

August 13-16, 2018Tuesday, August 14th 1:50 PM

2

Presentation Outline

• Title is representative of the entire task, but we’re going to focus on a single subtask here.– For detail in subtasks, please see Gannt charts or ask

about it later (there is good stuff there!)

• Relative permeability measurements of scCO2 in depositional environments identified as primary targets for carbon storage– Motivation– Methodology– Results to date

Motivation• CO2 storage resource

estimates for saline formations can be calculated with GCO2(Goodman et al 2016).

• The CO2 storage efficiency factor (Esaline) incorporates geologic and displacement terms to characterize the ability of CO2 to utilize the formation.

• The volumetric (EV) and microscopic (Ed) displacement terms are impacted by the relative permeability of the injection site.

3

𝐸𝐸𝜙𝜙𝐸𝐸𝐴𝐴 𝐸𝐸ℎ 𝐸𝐸𝑣𝑣 𝐸𝐸𝑑𝑑

P10 P90

10% of values

10% of values

11 + 𝑒𝑒 −𝐸𝐸𝐴𝐴

∗1

1 + 𝑒𝑒 −𝐸𝐸ℎ∗

1

1 + 𝑒𝑒 −𝐸𝐸𝜙𝜙∗

11 + 𝑒𝑒 −𝐸𝐸𝑉𝑉

∗1

1 + 𝑒𝑒 −𝐸𝐸𝐷𝐷

Log-odds stochastic approach

GCO2 = AthgθtotρEsaline

Esaline=EAEhEφEVEd

Motivation – Depositional Environments

• Gorecki et al (2009) calculated P10/P90 efficiency ranges for various depositional environments. – But limited information

on the scCO2/brine krcurves were available to perform this analysis.

• Experiments are being performed to expand this data set.

4

IEA, 2009/13. Development of Storage Coefficients for CO2 Storage in Deep Saline Formations, IEA Green house Gas R&D Programme (IEA GHG) October.

Motivation – Depositional Environments

27 scCO2/brine krtests completed

– 10 with multiple flow rates

5

Methodology

• Unsteady state scCO2 injections into brine saturated cores

6

Recent CO2 flood in Navajo sandstone

Mixing Vessel Injection

Pump

Heater

Confining Pump

Receiving Pump

CT Scanner

Heater Heater

Carbon Fiber Core Holder

Bypass LineΔP

6” L, 2” D cores Pp = 1400 psi (9.6 MPa) Pconf = 2000 psi (13.8 MPa) T = 140°F (60°C) 0.2 < Q < 6 ml/min

Experimental Methodology

7

Experimental Methodology

8

Experimental Methodology

9

Experimental Methodology

10

Experimental Methodology

11

Experimental Methodology

12

Experimental Methodology

13

Analysis Methodology

14

• Data collection– Baseline core properties (φ, k, pore volume)– Baseline CO2 and brine saturated CT scans– Dynamic measurements

• Differential pressure, injected CO2 volume, saturation (via CT scans)

• Used methods set forth by Krevor et al (2012) for saturation and Toth et al (2002) for mobility functions & kr calculations

Analysis Methodology

15

Analysis Methodology

16

Analysis Methodology

17

Technical Status• 27 tests completed, 10 with multiple flow rates

– Detailed sample information collected and to be reported with saturation and relative permeability results.

– All samples curated with International Geo Sample Number (ISGN) with the System for Earth Sample Registration (SESAR) – www.geosamples.org

18

Technical Status• Example results from Castlegate sandstone tests: deltaic to fluvial

19

Technical Status• Example results from Castlegate sandstone tests: deltaic to fluvial

20

Technical Status• Example results from Edwards Yellow tests: Carbonate

21

Technical Status• Example results from Edwards Yellow tests: Carbonate

22

Wormhole Generation

23

• Edwards Yellow (Carbonate)

• Q = 6, 4, 2, 1 ml/min

• Wormhole generation near to the inlet evolved over sequential CO2injections.

Injection

Exit

Wormhole Generation

24

Compare/Contrast Results across Cores

• Sandstones are relatively uniform in the relationship between kr and k

• Carbonates are dependent on the material sensitivity and initial permeability– Dolostones tend to be less prone to secondary

macro-porosity development and short-circuiting of fluid. They tend to behave more predictably like sandstone.

– Limestones (pure CaCO3) tend to wormhole significantly, which causes dynamic changes in the relationship between k and kr during the flow test

25

Accomplishments to Date

– 27 experiments completed. • Most depositional environments run with multiple cores.

– Only three depositional environments remain to be tested.• Lacustrine, alluvial and turbidite.

– Draft manuscript on methodology almost complete.• Introduction needs refining.

– Draft database for EDX created and populated.

26

Lessons Learned

– Core scale heterogeneity obviously an issue. – Low potential/uncertain reservoir systems

difficult to determine kr• Low permeability: not surprising

– Dynamic carbonate evolution is able to be captured with unsteady kr measurements

• Quantification of kr difficult (Vp is changing …) • We have been able to characterize this impact on

kr, and observed interesting behavior with respect to k and dissolution behavior. Early results, but planning to submit manuscript late ‘18 or early ’19.

27

Synergy Opportunities

We are very happy to utilize the skills and resources at NETL RIC to further the mission(s) of FE across portfolios. The number of ongoing collaborative studies is numerous, and if you identify places where we can help with your studies, please let me know.

28

Project Summary

– Key Findings• Dynamic carbonate evolution captured with unsteady kr measurements

– We have developed a methodology for correcting for these changes.

• We have been able to do a depositional environment, to completion, at a rate of 1 per 1-2 weeks.

– Next Steps• Submission of methods manuscript.• Completion of depositional environment experiments.• Finalization of database and publication to EDX.• Manuscript generation for dataset highlighting variation.

29

Appendix– These slides will not be discussed during the presentation, but

are mandatory.

30

31

Benefit to the Program • To improve assessments of CO2 storage for key reservoir classes,

basic research of critical properties at in situ conditions and linked to potential reservoir classes needs to be conducted. Work will focus on measuring relative permeability, residual saturation, and wettability for high priority depositional environments targeted for CO2 storage and developing accessible tools for reservoir modelers to access this data and utilize to reduce uncertainty in their estimates.

32

Project Overview Goals and Objectives

• Determination of non-rock specific relative permeability curves to reservoir scale assessments of CO2 migration results in higher levels of uncertainty than could be attained with more targeted models. By developing a set of relative permeability curves, and understanding how they vary with different depositional environments, the benefit of this task will be reduced uncertainty in CO2 migration in real world reservoirs.– Success is development and publication of an accessible database of

experimentally determined relative permeability curves of scCO2/brine through various high priority depositional environments.

33

Project Overview Brief highlights of additional subtask 13.1.2

• Improved brine-CO2 understanding in reservoirs, from pores to flow properties.

Measurement of scCO2/brine contact angles in pore space

Ca = 10-4

Simulated relative permeability in micro-CT

derived geometriesCT

ModelRock

Brine

CO2

Ca = 10-3

34

Organization Chart

• NETL Researchers: Johnathan Moore, Sarah Brown, Laura Dalton, Karl Jarvis, Bryan Tennant, Scott Workman, Aaron Boylan, Magdalena Gill, Jeong Choi, Michael Sabbatino, Leebyn Chong, Eugene Myshakin, Angela Goodman, Sean Sanguinito, Deepak Tapriyal, Foad Haeri, Fan Shi, Christopher Matranga, Greggory Breault, Samantha Fuchs, Paige Mackey, Thomas Paronish,

• ORISE Faculty: Cheng Chen (Virginia Tech), Goodarz Ahmadi (Clarkson University), Kevin Shanley (SUNY New Paltz), Brian Ellis (U of Michigan)

35

Gantt Chart – Task Overview

36

Gantt Chart – Subtask 1

37

Gantt Chart – Subtask 2

38

Gantt Chart – Subtask 3

39

Gantt Chart – Subtask 4

40

Gantt Chart – Subtask 5

Bibliography– List peer reviewed publications generated from the project per

the format of the examples below.– Publications for subtask 13.1.1 (focus of this talk) are in the draft

preparation stage. • Journal, one author:

– Gaus, I., 2010, Role and impact of CO2-rock interactions during CO2 storage in sedimentary rocks: International Journal of Greenhouse Gas Control, v. 4, p. 73-89, available at: XXXXXXX.com.

• Journal, multiple authors:– MacQuarrie, K., and Mayer, K.U., 2005, Reactive transport modeling in fractured rock: A state-

of-the-science review. Earth Science Reviews, v. 72, p. 189-227, available at: XXXXXXX.com.

• Publication:– Bethke, C.M., 1996, Geochemical reaction modeling, concepts and applications: New York,

Oxford University Press, 397 p.

41