husqvarna fs450 - healtech electronics · 2020. 4. 2. · husqvarna fs450 2016-s u p p l e m e n t...

Secure the bike on a stand.

www.healtech-electronics.com

for iQSE-1 + QSH-F2F

PAGE 1/3

Locate the fuel injector connector under the fuel tank.

Husqvarna FS450 2016-

S U P P L E M E N T A R Y M A N U A L

Connect the QSH connectors in-line with the injector

connectors.

(Make sure the QSH plugs marked with RED square are connected, and leave the unmarked coupler unused. You may connect the male and

female plugs of the unused pair together or isolate with tape.)

www.healtech-electronics.com PAGE 2/3

S U P P L E M E N T A R Y M A N U A L

Connect the QSH black wire terminal to the battery

negative terminal.

Use the original bolt of the gearbox shaft,

add the sensor and the original washer

exactly as shown in this photo.

a torque wrench, tighten the bolt until the shift arm is tight on the gearbox shaft.)

Mount the QSE sensor.

(Tighten the bolt in this position by about 6 Nm. If you do not have

for iQSE-1 + QSH-F2F

Husqvarna FS450 2016-

www.healtech-electronics.com PAGE 3/3

QuickShifter easy.Typical position for the

Secure the unit Properly.

S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSH-F2F

Husqvarna FS450 2016-