maggie - magne c in-line separa on filters - biokavitus · . 2 separa on mode cleaning mode model...

1

EQUIPMENT FOR REGENERATION OF INDUSTRIAL FLUIDS

MAGGIE - Magne�c in-line separa�on filters

High intensity magne�c separator fi�ed in-line.

The simplicity of the product design allows working 24/7 opera-

�on, while the footprint is four �mes smaller than tradi�onal

magne�c filters.

Single Maggie units can be combined to accommodate the flow

rate/loading characteris�cs of the applica�on.

Fully automated in-line systems built with very powerful rare-

earth magnets which, thanks to the unique features of internal

flow, remove par�cles down to 1-5 microns.

Maggie does not require any maintenance or the presence of

an operator, there are no consumables nor addi�onal manage-

ment costs.

Opera�on

The contaminated fluid enters the separator from the connec-

�on at the top using system pressure, requiring no addi�onal

pumps.

The flow rate within the device is reduced, maximizing the con-

tact �me between the par�cles and the magne�c field. In addi-

�on, the patented design forces the dirty fluid to follow a circu-

itous route inside the filter. The fluid comes into contact with

thin-walled stainless steel pipes, which contain magnets.

The magnets generate up to 10,000 gauss and are 15 �mes

more powerful than conven�onal magnets.

www.biokavitus.com

2

Separa�on mode Cleaning mode

Model Max flow rate l/m

Water / Oil

MG100 45-30

MG300 135-90

MG700 270-200

MG1200 480-320

MG2600 950-670

The combina�on of high intensity magnets, low flow rates and

the special internal pathway allow to improve the efficiency of

solid par�cles a�rac�on of 80% more than conven�onal mag-

ne�c separators. In addi�on, as a result of the par�cle aggrega-

�on process, non-magne�c material is also captured. The flow

process is illustrated in the Separa�on mode image.

When the amount of sludge is sufficient, this is captured by the

device and starts the automa�c cleaning system. Thanks to the

compressed air, the self-cleaning system is ac�vated by moving

the magnets upwards. The quick removal of the magne�c field

allows the release of all the captured par�cles.

The cleaning takes only a few seconds, and uses a small amount

of fluid (less than 1%). It also uses a single magnet movement.

(See image Cleaning mode).

Applica�ons

∗ Grinding

∗ Honing

∗ Engine & Parts washing

∗ Recovery on emulsions

∗ Coa�ng tanks and Cataphoresis

∗ Any applica�on where it is necessary to separate ferrous

parts from liquids

www.biokavitus.com

EQUIPMENT FOR REGENERATION OF INDUSTRIAL FLUIDS

MAGGIE - Magne�c in-line separa�on filters