mounting xto atomic ski bindings

2 3

4 6

7

5

8 9

NO OK

To be mounted by a ATOMIC Authorized dealer only.

ALP

INE

BIN

DIN

GS

MOUNTING1. Insert the Thin Plate in the seating ahead the

plate (�g. 1).2. Place it correctly with a rotational motion

(�g. 2).3. From the rear, slide the Toe piece on the

interface until it corresponds with or is just above your boot sole length using the manual lock to authorize the sliding (�g. 3 & 4).

4. From the rear, slide the Heel piece on the interface until it corresponds with or is just above your boot sole length using the manual lock to authorize the sliding (�g. 5).

5. Mount the Brake following the usual procedure (�g. 6).

ADJUSTING EXAMPLE6. Identify the length of the boot.7. If you have boot sole L 306 mm, adjust the Toe

on the 308 mm mark. The range in this case is 301 mm to 308 mm

(�g. 7).8. If you have chosen the L 306 mm, adjust the

Heel piece on the 312 location. The range in this case is 305 mm to 312 mm

(�g. 8) .9. Step in the boot and check forward pressure

(�g. 9) . The arrow on the housing must be within the

scribed area.

CONTENTS OF THE BOX› 2 Toes mounted on a sliding part› 2 Heels mounted on a sliding part› 2 Brakes› 2 Thin Plates› 1 Notice

MOUNTING & ADJUSTING

XTO 614, XTO 412, XTO 310

SMARTRAK

MOUNTING SMARTRAK

1