part replacement leverage biceps curl arm rom stop kits
Post on 04-Nov-2021
5 Views
Preview:
TRANSCRIPT
Part Replacement
STAR TRAC FITNESS 1 of 3 637-1504 Rev: A
Leverage Biceps Curl – Arm ROM Stop Kits
Leverage Biceps Curl (L-5001)
Parts Required:
• Leverage Right Arm Kit (PN: 731-5600-13-KT)
• Leverage Left Arm Kit (PN: 731-5601-13-KT)
Tools Required:
• Metric Hex Key Wrench Set or Specific Keys o 4 Hex Key o 5 Hex Key o 6 Hex Key
• Metric Socket Set or Specific Sockets o 10mm Socket
• Socket Ratchet (Corresponding to Socket Drive Size)
Instructions:
1. From the underside of the chest/arm pad (Fig. 1) remove the four button head cap screws using a 5mm hex key to take off the upholstery pad assembly.
Fig. 1
Part Replacement
STAR TRAC FITNESS 2 of 3 637-1504 Rev: A
2. From either left or right side arm – remove the center socket head cap screw (Fig. 2) using a 6mm hex key and
take off the chrome cap covering the center pivot shaft.
Fig. 2
3. Using the 10mm socket and 4mm hex key – remove the clocking shoulder bolt that runs thru the center of the
pivot shaft (Fig. 3) along with the corresponding nut and washers.
Fig. 3
Note: In the process of pulling out the shoulder bolt – Hold on
to the side counter balance¹ to
prevent a sudden rotation that may cut the kevlar belt.
1. Item not shown in image.
Part Replacement
STAR TRAC FITNESS 3 of 3 637-1504 Rev: A
4. Slide off whole arm assembly (Fig. 4) and verify the spacing machine washer remains on the pivot shaft to reuse
on new arm installation.
Fig. 4
5. Unpack the new corresponding arm assembly kit – notice the difference between the old & new arm assembly
kits.
Fig. 5
6. To install the new arm assembly – reverse the previous process from steps 4 to 2.
7. Repeat all the previous steps to remove and install the opposite side arm assembly.
top related