protect® 200 forte - texin.com.mx · ® 200 forte weight weaving count ... aatcc-15 aatcc-08...

Protect® 200 Forte

Weight

Weaving count

Breaking strength

Tear strength

Dimensional change

Composition Weave

Cuttable Width Visual

ASTM D-3774

ASTM D-629

ASTM D-3776

ASTM D-3775

ASTM D-5034

ASTM D-1424

AATCC-135

AATCC-61

AATCC-15

AATCC-08

inches

oz / yd2

yarns / inchyarns / inch

NNNN%%

gray scale gradegray scale gradegray scale gradegray scale gradegray scale gradegray scale grade

warp weft warp weft warp weft warp weft

change transference

acid alkaline

dry wet

Colorfastness to crocking

ASTM D-6413

inches

seconds

cal/cm 8.92

Afterflame time

ASTM F-1959

Colorfastness to washing

Colorfastness to perspiration

Characteristics Method Unit Specification

Momentary electric arc (ATPV)*

* Equals Arc Thermal Performance Value. The higher the value, the better the insulation against second degree burn.

C-IFRF200 Rev. 228 Abr 2016

88% cotton / 12% Nylon Twill 3 x 1 “S”

85 +/- 3 44 +/- 2

63 min.

7 +/- 5%

3622052320

minminminmin

+/- 3% 0+/- 3% 0

4 4

3 - 43

4

2

4

minmin

4 minminminmin

max

max

0 0

When washing FR garments, normal washing cycle should be used.

The maximum temperature for drying FR garments is 65 C (149 F).

FR garments should be removed from dryer immediately after they are dry, or slightly moist. Over drying may cause shrinkage.

Steam press or household ironing can be used on FR garments, asit is with cotton clothes.

Neutral soap should be applied for laundering process of FRfabrics.

Chlorine bleach should not be used in the laundering process of FR fabrics, neither by itself nor with other components.

Hydrogen peroxide should not be used on FR fabrics underany circumstance, either separate or as added to a detergent.

For best results when washing and drying the FR garments should be turned inside out during wash and dry.

The maximum temperature for washing FR garments is 50 C (122 F). 0

00

0

NFPA 2112, Standard on Flame-Resistant Garments for Protection of Industrial Personnel Against Flash Fire, 2012 Edition.

inchesTotal Nominal Width ASTM D-3774 65

Body Burn ASTM F-1930 % 9.90

ASTM F 1506, Standard Performance specification for Flame Resistant and Arc Rated Textile Materials for Wearing Apparelfor Use by Electrical Workers Exposed to Momentary Electric Arc and Related Thermal Hazards, 2010a Edition.

ASTM D-6413 /

No ignition, no dripping, no separation 10 %

Flame resistance after 100 cycles of washing and drying

NFPA 2112 Sec. 8.4Heat resistance and Thermal

NFPA 2112 Sec. 8.1

Shrinkage Resistance % Shrinkage max.

CAN/CGSB 155.20 standard on workwear for Protection Against Hydrocarbon Flash Fire, 2000 Edition.