report of project 18pulse
Post on 03-Apr-2018
225 Views
Preview:
TRANSCRIPT
-
7/28/2019 Report of Project 18pulse
1/6
[1]
Report
On
Simulation of 18 pilse
converter
Prepared by Guided By
Manish G Prajapati Mr Pramod S Modi
Submitted to
Electrical Engineering Department,
Faculty of technology and engineering
The M.S.U Baroda
Project
-
7/28/2019 Report of Project 18pulse
2/6
[2]
INDEX
1. INTRODUCTION2.SIMULATION CIRCUIT OF 18 PULSE CONVERTER3.SIMULATION RESULT OF 18 PULSE CONVERTER
-
7/28/2019 Report of Project 18pulse
3/6
[3]
1 INTRODUCTION
Eighteen-pulse converter are frequently specified by consulting engineersfor heating, ventilating and air conditioning applications because of their
theoretical ability to reduce harmonic current distortion, but very little
information has been published showing how eighteen-pulse converter perform
under actual operating conditions with unbalanced input line voltages. Thisreport presents test data which demonstrate that eighteen-pulse converter do
not achieve the level of harmonic mitigation most engineers expect and that
these converter may not meet the requirements of IEEE-519 under practical
operating conditions. In the mid 1960s when power semiconductors were only
available in limited current ratings, eighteen-pulse converter provided a simplerand more cost effective approach to achieving higher current ratings than directparalleling of power semiconductors. With this approach a converter could be
easily constructed with almost three times the horsepower available from the
largest six pulse converter. The technique is still employed today in very large
converter applications. In addition eighteen pulse converter have become a
popular approach to harmonic mitigation.
Eighteen pulse rectifiers can be constructed to operate in parallel or
series. In a series configuration, three six-pulse rectifiers, each generating one
third of the DC link voltage, are series connected. The series connection avoids,issues associated with current sharing and eliminates the need for an interphase
reactor. For applications where harmonic mitigation rather than high currentratings are the objective, this solution is much simpler to implement than the
parallel connection. Using the series rectifier connection, it is very easy to
construct an eighteen-pulse converter from a standard six-pulse converter if the
six-pulse converter has its DC bus terminals available or permits access to one
side of the DC bus. Many standard AC converter provide terminals in the DC
bus to accommodate an external DC link choke. These same terminals can be
used to add two external rectifiers converting the converter to eighteen-pulseoperation. The net result is a system solution well within the means of many
system integrators. A typical diagram of a series connected eighteen pulse
converter constructed from a standard sixpulse converter, two external rectifiers
and a conventional 18 pulse isolation transformer appears in figure 1.
The converter has terminals available to connect a DC link choke. These
terminals are used to connect the two external rectifiers in series with the
converter internal rectifier. The eightee pulse transformer is designed to provide
-
7/28/2019 Report of Project 18pulse
4/6
[4]
Fig 18 pulse converter
one third the normal input voltage to each of the three rectifiers at a 20 degree
phase displacement from each other. The 20-degree phase shift is obtained by
phase shifting the transformers secondary windings. The circuit in figure 1
simply uses an isolation transformer with a delta primary, and three delta
connected secondary windings, one shifted + 20 degrees, one shifted -20
degrees and one in phase with the primary.
-
7/28/2019 Report of Project 18pulse
5/6
[5]
2 SIMULATION OF 18 PULSE CONVERTER USING
MATLAB
Fig Shows the simulation circuit diagram of 18 pulse converter.
In this converter two zig zag transformer and one star star 3 phase
transformer are used. Upper zig zag Transformer provide the +20
phase difference and lower zig zag transformer provide the -20 Phase
difference. And the Middle star- star Transformer provide the 0
phase difference. Simulation result shows the output voltage has 18
pulse in the one AC supply cycle.
Fig Simulation circuit diagram of 18 pulse converter
-
7/28/2019 Report of Project 18pulse
6/6
[6]
3 SIMULATION RESULT OF 18 PULSE CONVERTER
top related