solidworks - gatechpurdy.gatech.edu/wp-content/uploads/2014/04/solidworks-adding...prof. purdy...
Post on 06-Apr-2018
223 Views
Preview:
TRANSCRIPT
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
The first way is to manually add parting lines. This can only be done if you have made a straight split. Start by hiding the top or bottom part in the feature tree.
Step 1
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Select the flat surface of the bottom part (See picture) and create a sketch on it.Step 2
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Right click on the outer edge and click select loop.Step 3
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
While the loop is selected, click on ‘Offset Entities’.Step 4
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Select reverse in the ‘Offset Entities’ options to make sure the yellow line is inside the blue line. Set the value such that the yellow line is just a little offset from the blue line. After this hit the green check mark to confirm. Then confirm the sketch.
Step 5
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Next, select the sketch you created, go to the ‘Features’ tab and select ‘Extruded Cut’.Step 6
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
In the ‘Cut-Extrude’ options enter the value for the gap you want, preferably 0.03 inches for a handheld device.After that check ‘Flip side to cut’. Hit confirm and you will have your parting line.
Step 7
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Unhide or show the part you decided to hide in the first step.Step 8
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Another way to add parting lines is by using ‘Lip/Grove’ Tool. Go to Insert > Fastening Feature > Lip/Grove.Step 9
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Another way to add parting lines is by using ‘Lip/Grove’ Tool. Go to Insert > Fastening Feature > Lip/Grove.Select the body/component on which to create a grove. (A)
Step 10
A
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Next, select the a straight edge (B) to define the direction of the grove.Step 11
A
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Select the face (A) on which to create the grove.Step 12
A
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Select the outer edge to greate a grove on.(A)Decide on the dimensions of the grove.(B)
Step 13
AA
B
ID@
GT
© 2
014,
Pro
f. P
urdy
Solidworks - Adding Parting Lines
Hit confirm and you will have the parting line.Step 14
top related