tcss 372a computer architecture
Post on 22-Feb-2016
29 Views
Preview:
DESCRIPTION
TRANSCRIPT
TCSS 372A
Computer Architecture
Getting Started
• Get acquainted (take pictures)
• Discuss purpose, scope, and expectations of the course
• Discuss personal expectations & strategy for doing well
• Review Web Page (http://faculty.washington.edu/lcrum)
• Review Syllabus, Textbook, and Simulator book
• Discuss Laboratory (CP 206D), Access, Etiquette, Equipment Check-out
• Discuss Homework Format
• Laboratory Report Format
CSS 372 - Lecture 1CSS 372 - Lecture 1
Chapter 3 – Connecting Computer Components with Buses
• Bus Structures
Synchronous, Asynchronous
• Typical Bus Signals
Two level, Tri-state, Wired Or
• Hierarchical Bus Organizations
• PCI Bus Example
What is a Bus?
• A communication pathway connecting two or more devices (Computers, Components, I/O, …)
• Usually broadcast • Often grouped
– A number of channels in one bus– e.g. 32 bit data bus is 32 separate single bit channels
• Power lines may not be shown
What do Buses look like?
– Parallel lines on circuit boards– Ribbon cables– Strip connectors on mother boards– Sets of wires
Physical Realization of Bus Architecture
Communication with Memory via a Bus
Communication with I/O via a Bus
CPU Communication via a Bus
Data Bus (Subset of Bus)
• Carries data– Remember that there is no difference between
“data” and “instruction” at this level
• Width is a key determinant of performance– 8, 16, 32, 64 bit
Address Bus (Subset of Bus)
• Identify the source or destination of data• e.g. CPU needs to read an instruction (data)
from a given location in memory• Bus width determines maximum memory
capacity of system– e.g. 8080 has 16 bit address bus giving 64k
address space
Control Bus (Subset of Bus)
• Control and timing information– Memory read/write signal(s)– Interrupt request/acknowledge signal(s)– Clock signal(s)– Etc.
Power/Ground (Subset of bus ?)
• Provides Power and Reference Levels for Devices
• May be several voltage levels
• Ground may be dispersed between signals
Types of Buses
• Synchronous• Asynchronous (Hand Shaking)
• Serial (Twisted pair, Coaxial Cable, ..)• Parallel (Ribbon Cable, Bundle of Wires,…)
• Dedicated- Separate data & address
lines• Multiplexed
- Shared lines- Address valid or data valid control line- Advantage - fewer lines- Disadvantages
More complex controlUltimate performance
Physical Considerations for Buses• Media (voltage, optic)
• Signal levels – the higher, the more immune to noise
• Noise Absorption – wires can pick up noise from neighboring wires
• Noise Generation – wires can be antennas
• Length Creates Delay ( reduces Bandwidth) Consumes Power Creates reflections – (Terminations become more critical)
Logic Threshold Voltage Levels
Signal Scheme Alternatives
• Totempole - High or Low output level Line always at a 1 level or 0 level
• Open collector, open drain, wired-or Line is nominally at a 1 level or 0 level – line is “pulled” to non-nominal level
• Tristate Has third state – open
• Differential Uses a pair of lines – the level is the difference of signals on the two lines.
Bus Challenges
• Lots of devices on one bus leads to:– Propagation delays
• Long data paths mean that co-ordination of bus use can adversely affect performance
– Traffic congestion• Too many devices communicating reduces bandwidth
• Alternative - Systems use multiple buses
Simple Computer Bus
++ clock(s), power(s), and ground(ss)
Notes: 1) Bus lines need to be properly terminated
2) Power lines are to furnish reference voltage, not power
Adding an Expansion Bus
Hierarchical Bus Structure
Bus Arbitration
• More than one module may need to control the bus e.g. CPUs and DMA controller
• Only one module may control the bus at one time
• Arbitration may be centralised or distributed
Centralised or Distributed Arbitration
• Centralised– Single hardware device controlling bus access
• Bus Controller• Arbiter
– May be part of CPU or separate
• Distributed– More than one module may claim the bus Need control logic on all these modules
Timing
• Co-ordination of events on bus• Synchronous
– Events determined by clock cycles– Control Bus includes clock line(s)– A single 1- 0 sequence is a bus cycle (or phase)– All devices can read clock line– Likely they sync on leading edge– Likely a single cycle for an event (may be multiple clock cycles or phases)
Timing Diagram ConventionsTiming Diagram Conventions
Synchronous Timing Diagram
Asynchronous Timing – Read Diagram
Asynchronous Timing – Write Diagram
Example - PCI Bus
• Peripheral Component Interconnection• Intel released to public domain• 32 or 64 bit• 50 lines
Typical PCI Bus Usage
Multiple PCI Bus Configuration
PCI Commands
• Transaction between initiator (master) and target
• Master claims bus
• Determine type of transaction– e.g. I/O read/write
• Address phase
• One or more data phases
PCI Read Timing Diagram
PCI Bus Arbiter
PCI Bus Arbitration Timing
top related