ao59041 - fitting instructions - evocare · zp hex bolt gr 4.6 m8x60 ... fitting instructions —...
TRANSCRIPT
Step 2
Insert 2 x reducer bush (SLE1006) into forward seat tilt lug (59DBAL2RED).
Step 3
Bolt the forward seat tilt lug (59DBAL2RED) to the frame using 2 x M8 x 35 Bolts (ZHSS9M) and 2 x
M8 Nyloc Nuts (ZNN6M). Locate M8 Nylon washers on either side of the lug (4 x NW6M).
Step 4
Bolt the cylinder end of the gas strut to the forward seat tilt lug (59DBAL2RED) using 1 x M8 x 35
Bolts (ZHSS9M) and 1 x M8 Nyloc Nut (ZNN6M). Locate M8 Nylon washers on either side of the lug
(2 x NW6M).
Step 5
Unbolt the ram end of the gas strut from the lower base frame brackets and fit 2 x M8 reducer
bushes (SLE1006) to the higher base frame bracket. (Remember to retain nut, bolt and washers).
Step 6
Bolt the ram end of the gas strut to the higher base frame brackets and fit 2 x M8 Nylon washers
(NW6M) and 1 x M8 Nylon Spacer (590NS) either side.
Step 7
Bolt the safety strap and buckle to the frame as shown using 2 x M8 x 35 bolts (ZHSS9M) and 2 x
Nylock Nuts (ZNN6M).