application of installation straps for essence windows...install pop rivets (mcmaster carr p/n:...
TRANSCRIPT
Application of Installation Straps
for Essence Windows
LA7939MM
More Technical Documents can be found at milgard.com/professionals
9000 EssenceTM Series
1
4” 4”
4”
Note: Straps shown bent up for illustration purposes.
16” max
spacing on
center
1
15/16”
1
2
3
4”
4”
Interior Exterior
Kerf
4”
Use 13/64” drill bit ½” deep (one wall)
Important: Drilling Deeper than ½” could penetrate interior walls.
15/16” from interior
4” off each corner (and mull ends if applicable)
16” maximum on centers around perimeter.
Drill for straps (See illustration 1)
12/4/2014 2
Application Instructions
(50) Installation Straps
(1) Bag of 100 Rivets
(1) Application Instructions
(1) 13/64” Drill Bit
Contents:Drill
#8 x 1 5/8” exterior grade screws – for install
Pop Rivet Tool
(Recommended – Allstar Performance # ALL18205)
Tools Required:
1.
2.
3.
4”4”
(If applicable – one each side when mulled)
2
LA7939MM
More Technical Documents can be found at milgard.com/professionals
9000 EssenceTM Series
Install pop rivets (McMaster Carr p/n: 97447A050 – 3/16” Dia., Grip range
0.126” – 0.25”, 0.45” length, 0.394” Head Dia., 310lbs shear strength, 500lbs
tensile strength) through every drilled hole to secure installation straps to
frame.
Important: Failure to use Milgard supplied rivets or specified McMaster
Carr rivet will decrease expected performance.
2
Standard Postition
Rivet
2
Standard Position
Pop Rivet installation straps to frame (See illustration 2)
12/4/2014 3
Application Instructions
Note: Recommended rivet tool for drill gun – All Star Performance model# ALL18205
LA7939MM
More Technical Documents can be found at milgard.com/professionals
9000 EssenceTM Series
3 Seal and shim assembled unit into opening according to AAMA-2400-10.
Secure unit using #8 exterior grade screws with minimum 1 ½”
penetration through each installation strap into the opening.
Minimum 1x screw per strap.
Bend straps if necessary.
Important for mulled units: Be sure to adequately support each window
while lifting window into opening. Failure to support could damage frame
corners.
3b
Install and seal unit in opening (See illustration 3)
12/4/2014 4
Application Instructions
3a
OR
STRAP FLAT
STRAP BENT