basics of using the mouse fusion 360 tutorial · [email protected] basics of using the...
TRANSCRIPT
Basics of Using the Mouse
Fusion 360 Tutorial
You need a copy of the Fusion Mouse Control Diagram to use with this tutorial
Firstly download the Demo Cube Fusion file
from the tutorials webpage (click here) and
save it to your computer.
Open Fusion 360 software and select New Design From
File. Navigate to where you saved the Demo Cube.f3d
file and click to open it and it will appear as below.
Press on the mouse roller to hold it down then move the cube
and workspace grid back and forth and up and down.
Roll the mouse roller to zoom in and out on the cube
Page 1 of 2
Move your mouse pointer near to the screen
view cube and left click click the HOME icon
Make sure you can do both
methods to ORBIT .
Then spend a couple of minutes
practising all the mouse moves.
The Left Click of the mouse is used to
select objects and Fusion functions.
Left click the cube to select it – you will
see it turn blue to show it is selected.
Now left click on the RIGHT Face on the
Fusion VIEW CUBE—you will see the CUBE
drawing go into RIGHT face view too.
ORBIT ROUND THE WORKSPACE to
view the drawing at different angles.
There are 2 methods, try them both:
Left click one of the
letters to select it.
1) Move the mouse over the VIEW CUBE (top
right of screen), left click and HOLD DOWN the
LEFT MOUSE button, move the cube and you
will see the screen rotate.
2) HOLD DOWN the keyboard SHIFT key + at the
same time, HOLD DOWN the mouse ROLLER,
move the mouse around to rotate the screen.
Page 2 of 2