beavis audio research

7/27/2019 Beavis Audio Research

1/4

The Huminator

Do you have a hum or other noise in your pedal(s)? A very likely cause is noise coming through your AC adaptors. Many cheap adaptors lackeven basic power supply filtering, so any noise in your AC mains ends up coming through to your pedal.But dont despair. Heres a usefuland simple project: build a box that will eliminate hum in your pedal caused by crappy cheap power supplies. And all the parts are easy tofind at your local Radio Shack.

The Schematic

Power enters through J1. D1 is a diode the protects against reverse-polarity, i.e. hooking up the wrong polarity adaptor. R2 limits the currentthe LED which expects 3 volts and would quickly burn out if directly connected to the 9 volt source. R1, C1 and C2 form the filter thatreduces hum.

The Parts List

Parts Substitution

If you cant find the exact parts listed above, you can substitute the following values/types:

LED: any kind of visible LED

3.3K ohm 1/2W 5% Carbon Film Resistor: any resistor of watt or higher, values anywhere from 1k to 4k ohms.

100 ohm 1/2W 5% Carbon Film Resistor: any 100 ohm resistor of watt or higher.

1N4001 Micro 1A diode: Could use just about any 1N400X value

0.047F 50V 10% PC-Mount Capacitor: any 0.047F film cap rated for 18 volts or more

vis Audio Research http://www.beavisaudio.com/Projects/Huminator/index.htm

4 30/07/2011 15:30


2/4

Let's Wire it up!

Ive arranged the wiring so it closely matches the schematic. That way it is easier to translate the schematic into actual wiring. The orangelines indicate the positive voltage and the yellow lines indicate the negative voltage, also known as ground. You can do the wiring bysoldering components directly to wires, or use a small bit of perfboard/circuit board.

To ensure this thing actually works for you, be sure to check the connections on the DC power jacks beforeyou solder them. Rememberthat the standard for pedal powering is tip-negative.

I decided to build mine by using two wires that acted as positive and negative connections. Then I soldered parts between the wires tomatch the schematic.


4 30/07/2011 15:30


3/4

After testing all the connections, screw the top on, and make up a quick label with my Brother PTouch label maker!

Make a Patch Cable

To make a power patch cable to go from the output of the Huminator to your pedal, get two 2.1mm DC plugs, and a length oftwo-conductor wire. Solder the two-conductor wire to each of the plugs and youre ready to go.

Hooking it Up

Plug your 9 volt AC/DC adaptor into the input. Then plug a 2.11mm DC to DC patch cord into the output of the Huminator and then into


4 30/07/2011 15:30


4/4

your pedal. No more hum!

(c) 2005-2010. Some Rights Reserved - This work is licensed under a Creative Commons License


4 30/07/2011 15 30

beavis audio research

Documents