BLOW MOULDINGF ull range of granulators for small bottles, tanksand j erry cans to 2 00 litre, coex fuel tanks 15 kg,IB C container, without pre-cutting

In line grinding of pieces from blowmolding and runners to 180°C

2 3 .000 bottles/h of 0,7 5 litre ground at start up,whithout fly-back

Your recycling needs. Our grinding solutions.

- Increased gripping ability for a bigger productivity, especially for voluminuos and light small blow mouldings and large productions

- Easy tool free access to screen, hopper, grinding chamber

- Specific cutting chember section- Water cooling, side discs, antiwear treatment and open rotor allow in-line grinding of pieces from blow molding and top&tail up to 180°C

- Arrow angle, cutting edge and blades setting to reduce cutting stress

Efficient solutionsRegrind quality material

Energy efficiency Easy operation and maintenance

Homogeneous and uniform regrind constantlyproduced. Mechanical and physical properties ofplastics unchanged.

Return on investment specific to each application, reliability through running time, maintenancefrequency according to production line down time.

Lowest running cost expressed in kWh/kg available on the market. Reaction power cosφ reduced to minimum thus having a direct impact on hourly energy cost.

Reduced mainenance frequency and downtimeby advance engineering design. Safety of operator during use and maintenance.

Your recycling needs. Our grinding solutions. © Tr

ia 20

16 -

BM01

rev.0

0

TRIA S.p.A.via E. F ermi, 82 009 3 Cologno Monz ese MIIT ALIA

tel +3 9 .02 .2 7 3 4 5 1fax +3 9 02 .2 5 4 2 101e-mail info@ triaplastics.comwww.triaplastics.com

BM SeriesB M 3 5 3 0B M 5 03 0

BM SeriesB M 6 04 2B M 9 04 2B M 12 04 2

BM SeriesB M 7 06 0B M 1106 0

System

Our granulators