bunting power point crosswalk safety

38
Charles Bunting PAD 4878 August 2013 Crosswalk Safety

Upload: chipbunting

Post on 16-May-2015

138 views

Category:

Business


0 download

TRANSCRIPT

Page 1: Bunting power point crosswalk safety

Charles BuntingPAD 4878

August 2013

Crosswalk Safety

Page 2: Bunting power point crosswalk safety

Problem Statement The purpose of this paper will be to determine the best pedestrian traffic control device to install on the 27 crosswalks on Fort Myers Beach, in order to increase pedestrian safety by encouraging drivers to yield to pedestrians in the crosswalk.

Page 3: Bunting power point crosswalk safety

T Town of Fort Myers BeachThe town was created in 1995. The town is run by a town council

consisting of a mayor, a vice mayor, and 3 council member.

The town employs a town manager, an administrative assistant, a town clerk, a contracts manager, and a receptionist.

The town has an annual budget of 28,656, 308 dollars.

Page 4: Bunting power point crosswalk safety

DepartmentsCommunity Development

Environmental Sciences Division

Finance Public WorksParks and Recreation

Page 5: Bunting power point crosswalk safety

Jurisdiction2.9 square miles of

landArea of water

extending 1000 feet from the shoreline

Population in 2,000 was 6,561 residents.

Median age for residents is 59.1 years.

Page 6: Bunting power point crosswalk safety

Three Main Business ClustersDowntown area known

as time square and the pier.

A mid island cluster which includes Town Hall, Bay Oaks, and the Library.

The south end of the island includes Santini Plaza, the Holiday Inn, CVS Pharmacy, and many high rise condominiums.

Page 7: Bunting power point crosswalk safety

The ProblemFrom November

through April the population increases dramatically when approximately 30,000 visitors descend on the island.

This triples the amount of traffic that travels on the islands main road known as Estero Blvd.

Page 8: Bunting power point crosswalk safety

The ProblemIn the past year,

four pedestrians have been killed while crossing Estero Blvd at crosswalks.

According to former Mayor Larry Kiker, there were 24 pedestrian accidents on the island last year.

Page 9: Bunting power point crosswalk safety

ProblemEstero is a very busy

road with major traffic congestion especially during the tourist season.

There has been a 20 percent increase in the number of pedestrian accidents this year (Kiker, 2013)

Page 10: Bunting power point crosswalk safety

Root CausesThe main cause of this problem is

congestion.Visitors are on vacation and do not pay

attention when they cross the road. They walk out in front of traffic assuming

the drivers will stop because they are in a crosswalk.

Likewise, the drivers are also on vacation and are paying attention to their surroundings, rather than the people in the crosswalk.

Page 11: Bunting power point crosswalk safety

StakeholdersResidents of Fort

Myers Beach.Visitors to Fort

Myers Beach.Town Council of

Fort Myers Beach.Lee County Sheriffs

Department.Lee County

Commission

Page 12: Bunting power point crosswalk safety

Miami Case StudyMiami has one of the highest

pedestrian fatality rates in the state. In order to solve this problem, the city

set up research teams to explore different countermeasures that could be used in the city to help make it a safer place for pedestrians.

These included “intelligent video pedestrian detection devices” and rapid flash beacons (RRFB).

Page 13: Bunting power point crosswalk safety

Miami ResultsThe results showed that some of the

countermeasures worked very well, while others had no significant effect on the behavior of the drivers or the pedestrians.

In Miami the use of the RRFBs increased the percentage of drivers who yielded to the pedestrians quite a bit.

At site #1 the yielding rate went from 0 percent to 65 percent. At site #2, the rate went from 1 percent to 92 percent.

Page 14: Bunting power point crosswalk safety

Seattle Case StudyCity leaders were

not happy with the fact that 398 pedestrians were killed from 2000-2009.

The city began installing overhead crosswalk signs at their busiest crosswalks.

Page 15: Bunting power point crosswalk safety

Seattle ResultsBefore the signs were installed, the driver

yielding rate was 45 percent. After the signs were installed, the driver

yielding rate went up to 52 percent. The crosswalk signs were also effective in

improving the behavior of the pedestrians in the crosswalk.

Before the signs were installed 58 percent of the pedestrians “ran, aborted, or hesitated” in crossing the road.

After the signs were installed, this rate went down to 43%.

Page 16: Bunting power point crosswalk safety

Lakeland Case StudyLakeland, Florida is located in Polk County where

there were 13 pedestrians killed last year (Parody, 2013).

The city has tried to improve the safety of the pedestrians in crosswalks by installing “flashing crosswalks.”

This device embeds lights into the roadway on both sides of a marked crosswalk.

When a pedestrian approaches the crosswalk, he or she will see a button to push that will turn on the flashing lights.

The flashing lights are designed to warn approaching drivers that someone is waiting to cross the road.

Page 17: Bunting power point crosswalk safety

Lakeland ResultsThe flashers were

effective in increasing the number of drivers who yielded to pedestrians.

Before the flashers were put in, the percentage of drivers who yielded to pedestrians was 15.8 percent.

After the flashers were installed, the rate went up to 41.0 percent.

Page 18: Bunting power point crosswalk safety

Lit Review One Huang, Zegeer, and Nassi (2000)Studied three different traffic control systems that have been employed in various locations to make it safer for pedestrians to cross the road.

Safety Cones in New YorkPedestrian Activated Flashing Amber Beacon

Stop for Pedestrians in Crosswalks signs.

Page 19: Bunting power point crosswalk safety

Results Huang, et al (2000)The device that

produced the most consistent results was the pedestrian safety cones.

Before the cones were put up, 69.8 percent of the drivers yielded to the pedestrians.

After the treatment, this rate went up to 82.1 percent.

Page 20: Bunting power point crosswalk safety

Lit Review Two:Federal Highway Administration (2001)Purpose was to find

out if marked crosswalks were effective traffic control devices.

Second objective was to come up with recommendations to improve pedestrian safety.

Page 21: Bunting power point crosswalk safety

Lit Review Three:Federal Highway Administration (2007)Studied

automated video detection of pedestrians.

Flashing beaconsIn street

pedestrian signsMedian refuge

islandsLasted 6 years

Page 22: Bunting power point crosswalk safety

Results FWA (2007)Most effective

were Rectangular Rapid Flashing Beacons.

Next was in street lighting

Pedestrian Countdown signals came in third

Yield here signs came in fourth.

Page 23: Bunting power point crosswalk safety

Lit Review Four: Do, et al (2011)The purpose of this study was to identify

some countermeasures that could make crosswalks safer for pedestrians.

The countermeasure study included RRFB, HAWK, Shared Lanes, and Crosswalk Markings.

Results showed signals were effective in reducing accidents by 69 percent.

The type of marking made a difference.Bar pairs and continental markings were

most effective.

Page 24: Bunting power point crosswalk safety

Lit Review Five: Bartlett, et al (2012)Bartlett, et al,

studied medians and pedestrian refuge areas.

Reports showed that using medians and walkways can reduce the number of pedestrians killed.

Page 25: Bunting power point crosswalk safety

Alternative 1: Rectangular Rapid Flashing BeaconRRFB contains two

LED flashers.Distance between

flashers is 9 inches.Flashing pattern

catches drivers attention.

Uses a stutter flash effect similar to EMS vehicles.

Page 26: Bunting power point crosswalk safety

Alternative 1: RRFBIn St. Petersburg, this

was the most effective countermeasure for increasing the number of drivers who yielded to pedestrians in the crosswalk.

The cost for two units ranges from 10,000 to 15,000 dollars.

Page 27: Bunting power point crosswalk safety

Alternative 2:HAWK Crossing SystemUses standard crosswalk signal with two

red lights over one yellow light.Light is dark until button is pushed and

system is activated.Yellow light changes from flashing to solid.Alerts drivers to stop.The two red lights come on and the

pedestrians get a walk signal.

Page 28: Bunting power point crosswalk safety

Alternative 2: HAWKOverall reviews were

good but there were two issues with this system.

The dark beacons are hard to see.

Some people think it is a broken traffic light and stop unnecessarily.

Cost is 80,000 dollars.

Page 29: Bunting power point crosswalk safety

Alternative 3-MediansMedians are areas between lanes of

traffic.Raised medians are the most effective

but they cost anywhere from 15,000 to 30,000 dollars per 100 feet.

The road also needs to be wide enough for the raised median.

Page 30: Bunting power point crosswalk safety

Alternative 3-Flashing CrosswalkFlashing crosswalks are a series of flashing

lights installed just below the pavement surface.

They warn motorists that pedestrians want to cross.

Cost is 15,000 to 18,000 dollars.They increase the yielding rate from 16

percent to 92 percent.

Page 31: Bunting power point crosswalk safety

MethodologyThe purpose of the ARP was to provide the

best solution to a problem in a public service organization.

The project was designed to use a quantative methodology to select the most effective traffic control device to improve pedestrian safety on Fort Myers Beach.

The comparative analysis will determine which of the four traffic devices studied will be the best choice for the Town of Fort Myers Beach.

Page 32: Bunting power point crosswalk safety

ResultsAlternative

Legal Financial Organizational

Political Total

#1-RRFB 50 45 33 38 166

#2-HAWK 40 42 32 32 146

#3-Medians

41 43 32 39 145

#5-FlashingCrosswalk

50 52 30 38 172

Page 33: Bunting power point crosswalk safety

Selection of Best Alternative The quantative and comparative

analysis concluded that the best alternative for Fort Myers Beach is the flashing crosswalks.

Alternative 4 scored 172 points.The rectangular rapid flashing beacon

came in second with 166 points.The raised medians was third at 146.HAWK system came in last with 145.

Page 34: Bunting power point crosswalk safety

ImplementationYear One-Set up control crosswalks using only

zebra stripes to determine which 10 crosswalks will get the treatment.

YearTwo-Determine the total cost and work with Lee County to secure funding and install the treatment on the 10 crosswalks that were chosen.

YearThree-Begin the evaluation process which will compare the crosswalks with and without treatment to determine if the system is effective.

Year Four- If the system is effective, install it in the remaining crosswalks.

Page 35: Bunting power point crosswalk safety

EvaluationObserve and record the behaviors of

the drivers and the pedestrians as they interact with the crosswalk system.

Observe and record the number of times a driver or pedestrian is forced to take evasive action to avoid an accident in the crosswalk.

Study the number of accidents that have occurred in the crosswalk before and after the install.

Page 36: Bunting power point crosswalk safety

ConclusionThank you for

taking the time to listen to my presentation.

The Town of Fort Myers Beach should make every effort to install the flashing crosswalk to ensure the safety of all residents and visitors.

Page 37: Bunting power point crosswalk safety

ReferencesBartlett, Jennifer, Brett Graves, Theo Petritsch, and Tamara

Redmon. (2012). Proven countermeasures for pedestrian safety. Public Records. United States Department of Transportation. FHWA-HRT-12-003. Retrieved from www.flfhwa.dot.gov/publications/public roads 29 May 2013.

Do, Ann, Kay Fitzpatrick, Susan Chrysler, Jim Shurbutt, William Hunter, and Shawn Turner. (2011) Safety Strategies Study. Public Roads. United States Department of Transportation. FHWA Number: HRT-11-004. Retrieved from www.flhwa.dot.gov/publications/public roads. 20 May 2013

Federal Highway Administration.(2010). Safety benefits of raised medians and pedestrian refuge areas . United States Department of Transportation. Retrieved from http://safety.fhwa.dot.gov/ped_bike/tools_solve/medians_brochure/medians_brochure.pdf1 June 2013.

Page 38: Bunting power point crosswalk safety

References Godfrey, David. (1999). Kirkland's experience with in-

pavement flashing lights at crosswalks. Institute of Transportation Engineers Annual Meeting.  Retrieved from http://www.kirklandwa.gov/depart/Public_Works/Transportation___Streets/Kirkland_s_Experience_with_In-avement_Flashing_Crosswalks.htm?PageMode=Print. 29 May 2013.

Hefferan, Jennifer and Peter Laggerwey (2004). The city of Seatle, WA, USA, crosswalk and inventory improvement plan. ITE Journal. Retrieved from www. Ite.org/membersonly/itejournal/pdf/2/2004. 24 May 2013.

http://katana.hsrc.unc.edu/cms/downloads/Effects_Un_MarkedCrosswalks_Summary.pdf

Huang, Herman, Charles Zeeger, and Richard Nassi (2000). Effects of innovative pedestrian signs at unsignalized locations: three treatments. In Annual meeting compendium of technical papers [CD-ROM]. ITE. Washington, DC. Retrieved from http://www.ite.org/traffic/documents/AB00H5102.pdf. 17 May 2013.