8/14/2019 Burn Drive Motor Does Not Park

1/1

Burn Drive Motor Does Not Park

H:\Tech Support\Training\SMTSG - Burn Drive Motor Does Not Park.doc

Normal Operation Sequence

10 - Plug the Stove In

11 LED's indicate P.O.S.T.12 Burn Drive cycles three (3) times13 Exhaust Fan Runs for 30 min then OFF

20 - Startup Mode

21 Push ON Button & set Heat Level22 #1 LED on23 Number of LED's show Set Heat Level24 Burn Drive cycles three (3) times25 Feed Wheel Begins Feeding Fuel26 After 1 minutes, Air pump comes ON27 After 15 seconds, the Igniters turn ON28 Within 5 minutes, Smoke and than Flame29 Igniters turn OFF after Flame is established30 After 15 seconds the Air Pump goes OFF

31 Stove Ramps to Heat Level 432 After 20 minute Startup Period, stove ramps

up or down to User Set Heat Level

40 - Normal Run mode

41 Stove runs at User SET HEAT Level42 Ash Dump per Heat Level43 Stove ramps to Heat Level 4 during the Ash

Dump process44 Stove runs until User turns the Stove OFF

50 - Normal Shut Down Mode

51 Push the OFF Button52 Feeder Wheel Stops feeding Fuel53 1st 10 minutes Exhaust Fan Increases speed54 Next 20 minutes Exh. Fan runs at 50% speed55 After 30 min. total, Ash Dump, Stove is OFF

YES

NO

21 Push the ON Button

Burn Drive Motor cycles 3times and stops on switch24

YES

Does Brake ArmAssembly movefreely?

Free up Brake ArmAssemblyNO NO

YES

Does the BrakeArmature engageinto the Slot on the

wheel on the Motorshaft?

YES

InspectLimitSwitch forsticking

Adjust if possible

Not Possible

41, 42, 43, 44

Replace the Burn Drive Motor as perKit instructions

Repair or ReplaceLimit Switch as

necessary

Run Stove