7/29/2019 Camera IR549Es

1/1

INSTRUCTION MANUAL

1/3 SONY SUPERHAD CCD0 LUX (IR ON)8-20MM LENSWEATHERPROOF

FEATURES

TROUBLESHOOTING

COMPLIANCE DECLARATION

This device has been tested and found to comply with thelimits for a CE Class B digital device.This device complied with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1)This device may not cause harmful interference and(2)This device must accept any interference receivedincluding interference that may cause undesired operation.To assure continued compliance follow the attachedinstallation instructions and do not make any unauthorizedmodifications.

INSTALLATION TIPS

INSTALLATION PRECAUTIONS

NOTE: SONY is a registered trademark of Sony Corp.and mentioned herein as for identification purpose.

Signal System

Image Sensor

Sensitivity

Resolution

Lens

Lens Control

Power

Construction

Video Output

Weather Resistance

LED wave length

HFOV

NTSC

1/3 Sony Exview II CCD

700 TVL Sony Effio

12VDC +10%

Aluminum Housing

1.0Vp-p (75 ohm, composite)

Ip66

65PCS 850mm IR LED

14.5 - 33

More than 50dB

Manual Focus

8-20mm

0.1 lux (B/W) 0 lux (IR On)

S/N Ratio

1.Best results are achieved when the camera is following lightdirection and looking down on the subject area

2.Areas with a bright background may cause degradation of theimage. If possible position your camera so that it doesnt pointtowards a very bright light source

3.Do not cut the DC power cable of the Camera to fit with anotherpower source. This may damage the Camera and void your warranty

4.Please test all devices before final installation as it is far easierto rectify problems at this stage

1.No picture on the screena.Check that all video cables are correctly connected.b.Check that all connected devices are powered on.c.Confirm 12VDC power supply provides enough current.d.The BNC cable is not terninated properly

2.Poor image qualitya.Is the lens out of focus?b.Is the lens dirty?c.Is the monitor setup correctly?

3.The camera doesnt operate at night.Your cable run may be too long and you are experiencing a

drop in voltage. Use better cable or supply the powernear the camera

1.Do not use old power source, if its 24VAC, it will damage thecamera and void warranty.

2.The installation should be made by qualified service personneland should conform to all local regulatory codes.

3.To make a hole on the wall to hide connecting cables. ensurethat no service cables, water or gas pips are buried in the wall

before drilling.4.Select the location where the camera weight can be properlysupported and avoid getting rain drops directly on the camera

5. Avoid the following location for camera installation:A)Near an object that releases a strong magnetic or Electric

fieldB) Areas with strong vibrations

6.Incorrect cable connection may cause short circuit, fire ormalfunction and even damage the camera

7 .Never aim the camera at direct sunlight or at other intenselight source which could damage the image sensor

Connect

Connect

Use Extension cable connect camera to DVR or Monitor withBNC video input. Use BNC to RCA adaptor for TV RCA input.illustration purpose only. cable, monitor and adapters not included.