cardmaking workshops your way dad is rad · “dad” with almond and bottom half with toffee,...
TRANSCRIPT
1© 2018 CTMH CO. UC
Exclusive Stamp Set:
Cardmaking Workshops Your Way‰
Dad Is Rad | 1 two-page layout, 1 single page, 4 cards
Featured Technique: Rock & Roll
Additional Materials Needed: Z2827 Almond Exclusive Inks™ Stamp PadZ2817 Crystal Blue Exclusive Inks™ Stamp PadZ2848 Sapphire Exclusive Inks™ Stamp PadZ2828 Toffee Exclusive Inks™ Stamp PadZ891 VersaMark™ Ink PadZ2066 Ranger™ Princess Gold Embossing PowderZ555 Craft Heater (available in North American market only)Z1979 Marvy® Uchida® LePen™ Journaling PenZ341 Glue Dots® Mini DotsZ2060 Thin 3-D Foam Tape
2
Cutting Diagrams:
1B2¾ µ 12
1M2¼ µ 12
1G1½ µ 12
1R1½ µ 12
3C2¾ µ 3¾
2E1 µ 12
4B¼ µ 5¼
3A1½ µ 4¼
1C2¼ µ 12
1N1¾ µ 12
2C*¾ µ 12
1H*7¼ µ 5¼
1U6¼ µ 4¼
4D5¼ µ ¼6D*
4 µ ½
© 2018 CTMH CO. UC
Getting Started:
• Gather all additional materials needed.• Light grey pieces on your cutting guide are scrapbooking project pieces. White pieces are left over paper.• Dark grey pieces on your cutting guide are cardmaking project pieces. • As you cut the paper, sort the pieces as indicated in the cutting guide, creating a stack for each project.
dark * light
Toffee cardstock
dark * light
Crystal Blue cardstock
Key:
= first cut | * = use back of paper = suggested stamp arrangement | = suggested Thin Cuts arrangement | = suggested Cricut® cut arrangement
(See project instructions for ink color and other details)
3© 2018 CTMH CO. UC
1I3½ µ 4¼
2B1¼ µ 12
1A & 1L¾ µ 12
5A*4 µ 5¼
1S3V µ 3V
1V3V µ 3V
3B1¼ µ 4¼
2D1¼ µ 12
6A3½ µ 5¼
2½
1¾
1¾ 4C*¼ µ 5¼
light * dark
Juniper cardstock
2B1¼ µ 12
1A & 1L¾ µ 12
5A*4 µ 5¼
1S3V µ 3V
1V3V µ 3V
3B1¼ µ 4¼
light *dark
Almond cardstock
2A2 µ 12
2F5¼ µ 7¼
4F2½ µ 3¼
4A & 4E¼ µ 5¼
5B*¾ µ 5½
5FV µ 2½
6C1¼ µ 4
dark * light
Sapphire cardstock
light * dark
Toffee cardstock
4© 2018 CTMH CO. UC
1E & 1P1 µ 12
1J3¼ µ 4
1T3 µ 3
1W3 µ 3
3E2½ µ 3½
5D2½ µ 3
4G2¼ µ 3
2G3 µ 1½
White Daisy cardstock
1F & 1Q½ µ 12
1D & 1O¼ µ 12
5C¼ µ 5½
2I¼ µ 4
5E¼ µ 2½
6B2½ µ 5¼
3D2X µ 3X
3F1 µ 1
(cut diagonal)
2H¼ µ 3½
1K1 µ ½
gold glitter paper
5
Project 1: Left Page
© 2018 CTMH CO. UC
2
½
1¼ 1
1A 1D
1I
1K
1J
1C
1B
1H
1G
1F1E
Photo5 × 7 (P)
1K:Paper: gold glitterTip: Hand trim to form arrow.
1J:Paper: White DaisyInk: VersaMark™ (with gold embossing powder)Tip: Heat emboss.Technique: Emboss the sentiment by stamping with VersaMark™ ink, sprinkling the wet image with embossing powder, shaking off any excess powder, and heating with the craft heater until the powder and ink melt together.
1A:Paper: light AlmondInks: Almond, SapphireTip: Stamp stitch lines first.
1E:Paper: White DaisyInks: Almond, Toffee
1. Prepare pieces shown above2. Use White Daisy cardstock for base page3. Attach 1A4. Tear one long edge of 1C5. Attach 1C to 1B6. Tear the long edge of 1B to mimic 1C7. Attach 1B 8. Attach 1D to top of 1C9. Attach 1E, 1F, and 1G
10. Attach 1H with thin 3-D foam tape11. Attach 1J to 1I12. Attach 1I with thin 3-D foam tape13. Attach 1K to 1J with glue dot14. Attach photo15. Embellish with clip and ribbon
Assemble:
Prepare:
6
Project 1: Right Page
1. Prepare pieces shown above2. Use White Daisy cardstock for base page3. Attach 1L4. Tear one long edge of 1N5. Attach 1N to 1M 6. Tear long edge of 1M to mimic 1N7. Attach 1M 8. Attach 1O to top of 1N9. Attach 1P, 1Q, and 1R
10. Attach 1T to 1S11. Attach 1S 12. Attach 1U with thin 3-D foam tape13. Attach 1W to 1V14. Attach 1V15. Attach photos16. Embellish with clips and ribbon
Assemble:
© 2018 CTMH CO. UC
½ ½
W
W W
1L 1O
1S1T
1W1V
1N
1M1U
1R
1Q1P
Photo3 × 3
Photo3 × 3
Photo4 × 6 (P)
2
1L:Paper: light AlmondInks: Almond, SapphireTip: Stamp stitch lines first.
1P:Paper: White DaisyInks: Almond, Toffee
Prepare:
7
2G:Paper: White DaisyInks: Crystal Blue, SapphireTips: Create this watercolor wash look by using the back side of the “#1” stamp and the second-generation stamping technique. Technique: Ink stamp in Crystal Blue, stamp it on scratch paper, then without re-inking stamp on 2G.
Project 2:
2B:Paper: light AlmondInk: Almond
1. Prepare pieces shown above2. Use White Daisy cardstock for base page3. Attach 2A, 2B, 2C, 2D, and 2E4. Attach 2F5. Dovetail left end of 2G6. Attach 2H behind 2G, allowing V" to show7. Trim 2G to match dovetail8. Attach 2G using thin 3-D foam tape9. Stamp diamonds on top left using Sapphire, Crystal Blue, and
Almond inks, as shown10. Stamp “YOU’RE” above top left of photo using
ombré stamping Tip: Ink top half of stamp with Crystal Blue and bottom half with Sapphire, overlapping colors in the middle.
11. Stamp two dots next to “YOU’RE” with Sapphire ink12. Stamp asterisks using first- and second-generation images,
as shown13. Attach 2I14. Embellish with ribbon
Tip: Tie a knot separately and attach it with a glue dot.
Assemble:
3¼
1
2A2B2C2D2E2I
2F
2G
2H
Photo5 × 7 (L)
Prepare:
FOLD
1¼¾
¾
3A
3B
3C 3D
3E 3F
8© 2018 CTMH CO. UC
Project 3: Prepare:
1. Prepare pieces shown above2. Attach 3B to 3A3. Attach 3A to card base4. Stamp asterisks with Crystal Blue ink, as shown5. Attach 3E to 3D with glue dots6. Attach 3D to 3C7. Attach 3C to card base with thin 3-D foam tape8. Attach 3F with glue dot9. Attach “#1” to 3E with thin 3-D foam tape
Assemble:
3E:Paper: White DaisyInks: Crystal Blue, SapphireTip: Stamp ¾" from top using ombré stamping technique.Technique: Ink top half of “YOU’RE” with Crystal Blue and bottom half with Sapphire, overlapping colors in the middle.
Paper: White DaisyInk: VersaMark™ (with gold embossing powder)Tips: Heat emboss and hand trim.Technique: Emboss the image by stamping with VersaMark™ ink, sprinkling the wet image with embossing powder, shaking off any excess powder, and heating with the craft heater until the powder and ink melt together.
3B:Paper: light AlmondInks: Almond, Sapphire, Toffee
9
FOLD
2½
1
4A4B4C
4D4E
4F4G
© 2018 CTMH CO. UC
Project 4: Prepare:
4G:Paper: White DaisyInks: Almond, Toffee, SapphireTips: Stamp diamonds using second-generation stamping technique. Stamp “Dad” using ombré stamping technique.Techniques: Ink diamonds with Sapphire and stamp on scratch paper. Re-ink just the tips and stamp half the image, as shown. Ink top half of “Dad” with Almond and bottom half with Toffee, overlapping colors in the middle, then stamp on 4G.
1. Prepare pieces shown above2. Attach 4A, 4B, 4C, 4D, and 4E to card base and trim
edges3. Embellish with ribbon and trim edges4. Attach 4G to 4F5. Attach 4F with thin 3-D foam tape6. Embellish with clip
Tip: Attach using gluedots.
Assemble:
10
FOLD
1¾
5A
5B
5D
5E5F
5C
© 2018 CTMH CO. UC
Project 5: Prepare:
5D:Paper: White DaisyInk: Almond, Toffee, SapphireTip: Stamp “YOU’RE” using ombré stamping technique.Technique: Ink top half of “YOU’RE” with Almond and bottom half with Toffee, overlapping colors in the middle, then stamp on 5D.
5B:Paper: light Sapphire Ink: Sapphire
1. Prepare piece shown above2. Attach 5A to card base3. Attach 5B and 5C4. Attach 5E and 5F to 5D5. Attach 5D with thin 3-D foam tape6. Embellish with clip
Assemble:
11
FOLD
16A6A 6B
6D6C
11© 2018 CTMH CO. UC
Project 6: Prepare:
1. Prepare pieces shown above2. Attach 6B behind 6A with glue dots
Tip: Trim edge of 6B V" from 6A as shown.3. Attach 6D behind 6C, allowing ¼" to show4. Attach 6C and 6D to 6A with thin 3-D foam tape
Tips: Leave ¼" of 6C and 6D hanging over the left side of 6A. Trim the right side even with 6B.
5. Attach 6A to card base Tips: Create a V" border between 6A and card base edges, as shown. Trim the left side of 6C and 6D.
6. Heat emboss two gold dots next to 6C Technique: Emboss the image by stamping with VersaMark™ ink, sprinkling wet image with embossing powder, shaking off any excess powder, and heating with the craft heater until the powder and ink melt together.
Assemble:
6A:Paper: light JuniperInk: SapphireTips: Mask off upper portion of stamp with a sticky note after inking.
6C:Paper: SapphireInk: VersaMark™ (with gold embossing powder)Tip: Mask sentiment and heat emboss.Technique: Emboss the image by stamping with VersaMark™ ink, sprinkling wet image with embossing powder, shaking off any excess powder, and heating with the craft heater until the powder and ink melt together.