certificate of registration - quantum plastics
TRANSCRIPT
CERTIFICATEOF REGISTRATION
This is to certify that the management system of:
Quantum PlasticsMain Site: Quantum Plastics – Victor Division,2135 B Avenue,Victor, Iowa, 52347, United States See appendix for additional sites and additional site scopes
has been registered by Intertek as conforming to the requirements of:
ISO 9001:2015The management system is applicable to:
Main site: Manufacture of custom injection molded parts, assembly and decorating.Additional site 2143 B Ave.: Manufacturing.Additional site 2161 B Ave.: Receiving and shipping.
Certificate Number:97-966h-03
Initial Certification Date:05 December 1997
Date of Certification Decision:15 January 2018
Issuing Date:02 February 2018
Valid Until:01 February 2021
Calin MoldoveanPresident, Business Assurance
Intertek Testing Services NA, Inc.,900 Chelmsford Street, Suite 301-3,Lowell, MA 01851.USA.
In the issuance of this certificate, Intertek assumes no liability to any party other than to the Client, and then only in accordance with the agreed upon Certification Agreement. This certificate’s validity is subject to the organization maintaining their system in accordance with Intertek’s requirements for systems certification. Validity may be confirmed via email at [email protected] or by scanning the code to the right with a smartphone. The certificate remains the property of Intertek, to whom it must be returned upon request.
Page 1 of 2
APPENDIX TOCERTIFICATE OFREGISTRATION
This appendix identifies the locations covered by the management system of:
Quantum PlasticsThis appendix is linked to the Main Certificate # 97-966h-03 and cannot be shown nor reproduced without it.
Quantum Plastics
Quantum Plastics – Victor Division,2143 B Avenue,Victor, Iowa, 52347, United States
Quantum Plastics – Victor Division,2161 B Avenue ,Victor, Iowa, 52347, United States
Quantum Plastics
Quantum Plastics – Fort Smith Division,3730 Wheeler Avenue,Fort Smith, Arkansas, 72901, United States
Manufacture of custom injection molded parts, assembly and decorating.
In the issuance of this certificate, Intertek assumes no liability to any party other than to the Client, and then only in accordance with the agreed upon Certification Agreement. This certificate’s validity is subject to the organization maintaining their system in accordance with Intertek’s requirements for systems certification. Validity may be confirmed via email at [email protected] or by scanning the code to the right with a smartphone. The certificate remains the property of Intertek, to whom it must be returned upon request.
Page 2 of 2