classification of igneous rocks€¦ · a classification of the phaneritic igneous rocks:...
TRANSCRIPT
-
Classification of Igneous Rocks Textures:
Glassy- no crystals formed Aphanitic- crystals too small to see by eye Phaneritic- can see the constituent minerals
Fine grained- < 1 mm diameter Medium grained- 1-5 mm diameter Coarse grained- 5-50 mm diameter Very coarse grained- > 50 mm diameter
Porphyritic- bimodal grain size distribution Pyroclastic- amalgamated igneous fragments
-
Glassy à cooled very rapidly
Glassy-skinned pillow lava
-
Aphanitic à crystallized rapidly (volcanic/extrusive)
-
Phaneritic à crystallized slowly (plutonic/intrusive)
-
Porphyritic à 2 phases of crystallization
-
Classification of Igneous Rocks
Figure 2.5. Classification of the pyroclastic rocks. After Fisher (1966) Earth Sci. Rev., 1, 287-298.
Step 1: Is rock pyroclastic (i.e., >75% pyroclasts)? If so, name based on clast size/type • Bombs molten during
fragmentation, typically rounded/stretched
• Blocks angular or broken • Lithic mostly rock fragments;
vitric mostly glass; or crystal • Add composition if known, e.g.,
“rhyolitic tuff”
-
Compositional Classification
The number of different rock type names used by working petrologists is huge (e.g., check
out Table 2.1 in your text).
This is partly due to people mixing old and new terminology; we will try to stick to IUGS
systemized nomenclature.
… and also due to rare compositions, e.g. highly alkaline rocks (
-
Compositional Classes: Felsic v. Mafic
Mostly light (but remember obsidian)
Mostly dark
Refers to individual minerals or to rocks dominated by them
pyroxene amphibole
Na
-
Igneous rocks: the low-alkali set Silicic/Felsic/ Acidic
Intermediate
Mafic/Basic
Ultramafic/Ultrabasic
-
Classification of Igneous Rocks
Figure 2.4. A chemical classification of volcanics based on total alkalis vs. silica. After Le Maitre (2002) . Igneous Rocks: A Classification and Glossary of Terms. Cambridge University Press.
Step 2: Is rock glassy or aphanitic (i.e., can’t determine minerals)? If so, name based on total alkali/SiO2 (TAS) •
-
Classification of Igneous Rocks
Figure 2.4. A chemical classification of volcanics based on total alkalis vs. silica. After Le Maitre (2002) . Igneous Rocks: A Classification and Glossary of Terms. Cambridge University Press.
Stolper et al. (2013)
Recently found on Mars; what is it??
-
McSween et al. (2009)
Mars: A basaltic world(?)
Jake_M mugearite
-
1. Primary minerals • Olivine: (Mg,Fe)2SiO4 • Pyroxene: (Ca,Mg,Fe)SiO3 • Plagioclase: CaAl2Si2O8 – NaAlSi3O8
2. Oxides • Hematite: Fe2O3
3. Salts • Halite: NaCl • Gypsum: CaSO4·2H2O • Calcite: CaCO3
4. Secondary silicates (incl. phyllosilicates—e.g., clays) • Kaolinite: Al2Si2O5(OH)4 • Nontronite: Fe2(Al,Si)4O10(OH)2Na0.3·nH2O
Caveat: alteration can also change bulk chemistry
Increasing water
alteration
-
New: remotely sensed rocks w/
-
Rock classification based on mineralogy
Can estimate abundances from hand samples, but thin section “point counting” is
more accurate
Step 3: If possible, determine the modal mineralogy…
-
Mineral-based Classification of Volcanic Rocks
Figure 2.3. A classification and nomenclature of volcanic rocks. After IUGS.
Step 4: Calculate… Q’ = % quartz (or other polymorph) A’ = % alkali feldspar (An
-
Mineral-based Classification of Volcanic Rocks
Step 5: If Q’ + A’ + P’ + F’ > 10% then normalize these to exclude all other phases (including all mafics!) E.g., Q = 100 * Q’ / (Q’ + A’ + P’) [Note either Q’ or F’ will be 0]
-
Mineral-based Classification of Volcanic Rocks
Step 6: Determine name from Q or F, and feldspar ratio: 100P/(P+A) à left-to-right position If andesite/basalt: Basalt defined by 35% Replace “foid” with the specific mineral, e.g. nepheline
-
Figure 2.2a. A classification of the phaneritic igneous rocks: Phaneritic rocks with more than 10% (quartz + feldspar + feldspathoids). After IUGS.
Mineral-based Classification of Plutonic Rocks Steps are analogous… If diorite/gabbro: Gabbro defined by plagioclase with An>50 But for >90% mafics, need a different chart…
-
Classification of Mafic Intrusive Rocks
Figure 2.2b. A classification of the phaneritic igneous rocks: Gabbroic rocks. After IUGS.
A simplified version… E.g., orthopyroxene gabbro should really be “norite” **
-
Classification of Ultramafic Intrusives
Figure 2.2c. A classification of the phaneritic igneous rocks: Ultramafic rocks. After IUGS.
-
Figure 2.2a. A classification of the phaneritic igneous rocks: Phaneritic rocks with more than 10% (quartz + feldspar + feldspathoids). After IUGS.
An example… Modal mineralogy of 18% qtz, 32% plag, 27% K-spar, 12% biotite, 8% hornblende, 3% opaques Q’ + A’ + P’ = 77 > 10 Renormalize à Q = 23, P = 42, A = 35 100P/(P+A) = 55
è granite **
-
Figure 2.2a. A classification of the phaneritic igneous rocks: Phaneritic rocks with more than 10% (quartz + feldspar + feldspathoids). After IUGS.
Another example Modal mineralogy of 11% nepheline, 2% plag, 70% K-spar, and other mafic/accessory phases
?? è nepheline syenite **
-
Revisiting the effects of H2O H2O solubility in melt increases with P, SiO2 (H2O à OH– + H+, breaks -Si-O-Si- to form -Si-OH and HO-Si?)
— assumes SiO4 polymers in melt
Note 10 wt% H2O is >50 mol% ! 2-3 wt% more realistic
-
Dry and water-saturated solidi for some common rock types
All solidi are greatly lowered by water, and the P-T curves become non-monotonic More silicic melts tend to be wetter à more likely to recrystallize in plutons during ~isothermal ascent
Figure 7-21. H2O-saturated (solid) and H2O-free (dashed) solidi (beginning of melting) for granodiorite (Robertson and Wyllie, 1971), gabbro (Lambert and Wyllie, 1972) and peridotite (H2O-saturated: Kushiro et al., 1968; dry: Hirschman, 2000).