Current and Resistance

112-11-2014

FCI

Define the current.

Understand the microscopic description of current.

Discuss the rat at which the power transfer to a device in an electric current.

212-11-2014FCI

2-1 Electric current

2-2 Resistance and Ohm’s Law

2-3 Current density, conductivity and

resistivity

2-4 Electrical Energy and Power

312-11-2014FCI

The resistance of an ohmic conductor is proportional to its length, L, and inversely proportional to its cross-sectional area, A

◦ ρ is the constant of proportionality and is called the resistivity of the material

4

LR

A

12-11-2014FCI

For most metals, resistivity increases with increasing temperature

◦With a higher temperature, the metal’s constituent atoms vibrate with increasing amplitude

◦The electrons find it more difficult to pass through the atoms

512-11-2014FCI

For most metals, resistivity increases approximately linearly with temperature over a limited temperature range

◦ ρ is the resistivity at some temperature T◦ ρo is the resistivity at some reference

temperature To To is usually taken to be 20° C is the temperature coefficient of

resistivity

6

)]TT(1[ oo

12-11-2014FCI

Since the resistance of a conductor with uniform cross sectional area is proportional to the resistivity, you can find the effect of temperature on resistance

7

)]TT(1[RR oo

12-11-2014FCI

o o(T) 1 T T

o

1= temperature coefficient of resistivity

T

o oR(T) R 1 T T

RA

12-11-2014 8FCI

A class of materials and compounds whose resistances fall to virtually zero below a certain temperature, TC

◦ TC is called the critical temperature

The graph is the same as a normal metal above TC, but suddenly drops to zero at TC

12-11-2014 9FCI

In a circuit, as a charge moves through the battery, the electrical potential energy of the system is increased by ΔQΔV

As the charge moves through a resistor, it loses this potential energy during collisions with atoms in the resistor◦The temperature of the resistor will

increase

1012-11-2014FCI

Consider the circuit shown

Imagine a quantity of positive charge, Q, moving around the circuit from point A back to point A

1112-11-2014FCI

Point A is the reference point◦ It is grounded and its potential

is taken to be zero

As the charge moves through the battery from A to B, the potential energy of the system increases by QV◦ The chemical energy of the

battery decreases by the same amount

1212-11-2014FCI

As the charge moves through the resistor, from C to D, it loses energy in collisions with the atoms of the resistor

The energy is transferred to internal energy

13

When the charge returns to A, the net result is that some chemical energy of the battery has been delivered to the resistor and caused its temperature to rise

12-11-2014FCI

The rate at which the energy is lost is the power

From Ohm’s Law, alternate forms of power are

14

QV I V

t

22 V

I RR

12-11-2014FCI

The SI unit of power is Watt (W)◦“I “ must be in “Amperes”,” R” in ohms

and “V’ in Volts

The unit of energy used by electric companies is the kilowatt-hour◦This is defined in terms of the unit of

power and the amount of time it is supplied

◦1 kWh = 3.60 x 106 J

1512-11-2014FCI

The same potential difference is applied to the two

lightbulbs shown in Figure .Which one of the following statements is true?

(a) The 30-W bulb carries the greater current and has the higher resistance.

(b) The 30-W bulb carries the greater current, but the 60-W bulb has the higher resistance.

1612-11-2014FCI

(c) The 30-W bulb has the higher resistance, but the 60-W bulb carries the greater current.

(d) The 60-W bulb carries the greater current and has the higher resistance.

1712-11-2014FCI

(c). Because the potential difference ∆V is the

same across the two bulbs and because the

power delivered to a conductor is P= I V, the 60-

W bulb, with its higher power rating, must carry

the greater current.

The 30-W bulb has the higher resistance because

it draws less current at the same potential

difference.

1812-11-2014FCI

1912-11-2014FCI

2012-11-2014FCI

1. The electric current “I “ in a conductor is defined as

where dQ is the charge that passes through a cross section of the conductor in a time interval dt. The SI unit of current is the ampere (A), where 1 A = 1 C/s.

The average current in a conductor is related to the motion of the charge carriers through the relationship

21

where n is the density of charge carriers, q is the charge on each carrier, vd is the drift speed, and A is the cross-

sectional area of the conductor.12-11-2014FCI

2. The current density in an ohmic conductor is proportional to the electric field according to the expression

22

The proportionality constant σ is called the conductivity of the

material of which the conductor is made. The inverse of & is

known as resistivity ρ (that is, ρ = 1/ σ).

The last equation is known as Ohm’s law, and a material is said

to obey this law if the ratio of its current density J to its applied

electric field E is a constant that is independent of

the applied field.

12-11-2014FCI

23

3. The resistance R of a conductor is defined as

where ∆V is the potential difference across it, and I is the

current it carries. The SI unit of resistance is volts per

ampere, which is defined to be 1 ohm; that is, 1Ω = 1 V/A.

If the resistance is independent of the applied potential

difference, the conductor obeys Ohm’s law.

12-11-2014FCI

4. If a potential difference ∆V is maintained across a circuit element, the power, or rate at which energy is supplied to the element, is

24

Because the potential difference across a resistor is given by ∆V = IR, we can express the power delivered to a resistor in the form

The energy delivered to a resistor by electrical transmission appears in the form of internal energy in the resistor.

12-11-2014FCI

1. The charge carriers in metals areA. electrons.B. positrons.C. protons.D. a mix of protons and electrons.

12-11-2014FCI 25

2. A battery is connected to a resistor. Increasing the resistance of the resistor

will

A. increase the current in the circuit. B. decrease the current in the circuit. C. not affect the current in the circuit.

12-11-2014FCI 26

3. A battery is connected to a resistor. As charge flows, the chemical energy of the battery is dissipated as

A. current. B. voltage. C. charge. D. thermal energy

12-11-2014FCI 27