Manually set the PWS NIC Speed Link to 10Mbps Full Duplex before attempting to

communicated with Xerox DC5000/DC5000AP machines.

Note: The PWS NIC Speed Link must be set back to Auto Negotiation after

DC5000/DC5000AP service so the PWS performance will go back to normal.

INSTRUCTIONS

Follow the steps below to configure the PWS NIC:

Enter the PWS Control Panel.

Select Network and Sharing Center.

Select Change Adapter Setting.

Use the mouse right button to click on the Local Area Connection icon.

Select Properties.

Click on the Configure button.

Select the Link Speed tab.

In the Speed and Duplex section, select 10 Mbps Full Duplex from the drop list.

Select Ok.

Select the red X to close the network Connection screen.

Note: The instruction may vary if a different NIC card driver is installed in the PWS.

EXPIRATION: 12/31/2012

This is what the instructions should say

INSTRUCTIONS

Follow the steps below to configure the PWS NIC:

1. Enter the PWS Control PanelControl PanelControl PanelControl Panel.

2. Select Network and InternetNetwork and InternetNetwork and InternetNetwork and Internet (see figure 1)

Figure 1

3. Select Network and Sharing CenterNetwork and Sharing CenterNetwork and Sharing CenterNetwork and Sharing Center (see figure 2)

Figure 2

4. Select Change adapter settings Change adapter settings Change adapter settings Change adapter settings (see figure 3)

Figure 3

5. Use the mouse right button to click on the Local Are ConnectionLocal Are ConnectionLocal Are ConnectionLocal Are Connection icon. (see

figure 4)

Figure 4

6. Select PropertiesPropertiesPropertiesProperties.

7. Click on the ConfigureConfigureConfigureConfigure button. (see figure 5)

Figure 5

8. Select the AdvancedAdvancedAdvancedAdvanced tab. (see figure 6)

Figure 6

9. In Property section select Link Speed & DuplexLink Speed & DuplexLink Speed & DuplexLink Speed & Duplex, then under ValueValueValueValue select 10 Mbps 10 Mbps 10 Mbps 10 Mbps

Full Duplex Full Duplex Full Duplex Full Duplex (see figure 7)

Figure 7

10. Select OKOKOKOK

11. Select the red XXXX to close the network Connection screen.