Removing – Unclip dash panel side cover -1- using a suitable screwdriver and remove.

– Insert a suitable flat screwdriver through side openings -A- and -B- between vent and seal and lever vent -2- alternately through these openings in direction -C-.

– When removing vent -2- in direction -C-, disconnect connector -3- at the rear.

Removing center vent

– Put fingers of both hands in bottom row of ribs -A- and press centre vent -1- firmly downwards so that locking lugs -B- are released from their holder.

Note When removing the vents, sit between the front seats so that you can apply sufficient force.

If the outer locking lugs -B- do not disengage, grasp the vent at these points and press the centre vent downwards, pulling it out slightly at the same time.

– Grasp centre vent -1- at the points -C-, which has been lifted slightly off dash panel opening by

pressing vent downwards.

– Now push centre vent in direction of arrow -D- in order to release lower locking lugs and pull vent out slightly.

Separate connectors -2- at rear before removing centre vent in direction of -arrow-.–