diy jewelry - galvanized seed bead bracelet
TRANSCRIPT
DIY Jewelry - Galvanized Seed Bead Bracelet
Materials Needed
• 1 Yard of 1.5mm Leather
• 2 Yard of 0.6mm Knotting Cord
• 1 Bag of 6/0 Seed Beads
• 1 Button
• 1 Bottle of Super New Glue
Begin by centering your button on your 1.5mm leather cord. Create a
Macramé knot next to the button to begin your bracelet.
Once you’ve completed your knot bring your cord under your leather
crossing through 1 seed bead, and bringing your cords over your leather.
Bring your cord back under your leather, crossing through 2 more seed
beads this time bring your cord back over and pull tightly again. Repeat
with 3 seed beads, and finally with 4. We will repeat with 4 seed beads
under the end of the pattern (Desired length).
Once your competed your pattern to the desired length, you’ll sure the
beads with a macrame knot (The same way we stared, but you’ll need a
drop of glue at the ends of your cord before nipping.) Once your knot is
completed, you’ll need to create an over-hand knot for your button to slide
into.
Now your bracelet is ready to show off,
We hope you enjoyed this project.