doc.: ieee 802.11-11/1109r0 submission month year tom siep, csrslide 1 amendment creation process...
TRANSCRIPT
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Month Year
Slide 1
Amendment Creation ProcessDate: YYYY-MM-DD
Name Affiliations Address Phone email Tom Siep CSR 3779 Pecan Acres
Drive, Farmersville, TX, USA
+1 214 558 4358
Authors:
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
August 2011
Slide 2
Abstract
• Overview of process• Suggested areas which may need to be modified to
create an 11ai amendment to 802.11mb Rev 9
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Overview of Process
August 2011
Slide 3
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Draft CreationAugust 2011
Slide 4
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Example of Standard Amendment Proposal Citation
• Document 11/1014r0
August 2011
Slide 5
Insert element identifier (IDs) 143 through 145 and change the Reserved row in Table 8-53 as follows (note the entire table is not shown here): 8.4.2.1 General Information Element Element ID Length (in octets) Extensible IP address configuration during association
143 3 Yes
IPv4 address 144 Variable IPv6 address 145 variable
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Possible Areas for Modification
• Section 3 – Definitions and Acronyms• Section 5 – MAC Service definition• Section 6 – Layer Management• Section 8 – Frame Formats• Section 9 – MAC sublayer functional description• Section 10 – MLME• Section 11 – Security• Section 12 – Fast BSS transition (?)• New section for AP functionality?
August 2011
Slide 6
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 3 – Definitions and Acronyms
• Any new terms or acronyms• Examples
– FILS– Link Setup Time
August 2011
Slide 7
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 5 – MAC Service definition
• Service primitives• Interface definition to upper layers
August 2011
Slide 8
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 6 – Layer Management
August 2011
Slide 9
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 8 – Frame Formats
• Over the air communication between devices• Typically STA to AP (and back)
August 2011
Slide 10
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 9 – MAC sublayer functional description
• Functions required to process FILS
August 2011
Slide 11
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 10 – MLME
• Synchronization, Power management, Authentication, …
• May want to add new section
August 2011
Slide 12
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 11 – Security
• If changes– Complete description of change– Analysis of security to verify it is not compromised.
August 2011
Slide 13
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Section 12 – Fast BSS transition (?)
August 2011
Slide 14
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
New section for AP functionality?
August 2011
Slide 15
doc.: IEEE 802.11-11/1109r0
Submission Tom Siep, CSR
Month Year
Slide 16
References
• IEEE Draft P802.11-REVmb™/D9.0, May 2011• 11-11-1014-00-00ai-ip-config-during-assoc-norm.docx