For more details on mounting or additional technical information, visit the Connected Sites knowledge base at samsara.com/support

1x

1x

4x

4x 2x 1x

1x 1x 1x

INSTALL GUIDE — FMSGUIDE D’INSTALLATION — FMSINSTALLATIONSANLEITUNG — FMSGUÍA DE INSTALACIÓN — FMSGUIDA ALL’INSTALLAZIONE — FMSINSTALLATIEGIDS — FMS

Dome IP Site CameraSC11

samsara.com/support 2

T10 5.5 ~ 6.4 mm

TOP VIEW

4

1 2

3

Remove lid with the Torx driver provided.

Attach cable gland if using outdoors or in a wet environment.

Verify camera is powered before mounting.

If necessary, install drywall anchors using the alignment sticker. Feed the ethernet cable through the middle opening of the back plate, then fasten the back plate to the mounting surface using the provided screws.

samsara.com/support 3

Add Cameras

TOP VIEW

0 ~ 352º0 ~ 352º

5 6

7a 7b

When your camera is plugged into the network, add the camera to your dashboard by going to Devices > Cameras > Add Cameras. You can identify your camera in the results via the serial and/or MAC address printed on the camera's box.

Once added, confirm the camera is positioned correctly by viewing it in the mobile app or dashboard. The next steps demonstrate the different axes you can use to adjust the camera's field of view.

Optional: Twist camera base to rotate.

Optional: Tilt lens. May need to rotate 180º to tilt in the reverse direction.

samsara.com/support 4

T10

TOP VIEW

0 ~ 75º

Tilt Arm

TOP VIEW

9

7c 8

Optional: Rotate aperture where needed.

This is the top of the camera and should be mounted with this side up.

Once the aperture is properly aimed, use the Torx driver to secure the lid.