At this Recycling Center in California, this 40 yard steel dumpster is rolled over this concrete twice a week with these abrasive steel wheels, causing a great deal
of damage to the unprotected concrete. Rust Bullet not only creates a moisture barrier that seals concrete from oils, water and chemicals but it will also make your concrete stronger and more wear resistant, adding years to its life. Rust Bullet for concrete is easy to apply. Just rinse off the dirt and debris, let the surface dry fully and apply.
SUPERIOR PATENTED TECHNOLOGY
SUPERIOR PATENTED TECHNOLOGY
Proven By Certified Laboratory TestingPublished at www.RustBullet.com
Awarded an Unprecedented Two United States PatentsApplies Directly Over Most Any Clean Surface Concrete, Metal, Wood, Fiberglass and Many Other Surfaces
Little or No Surface Preparation RequiredBrush, Roll or Spray ApplicationsSuperior AdhesionAllows for Easy Clean-up of SpillsChemical ResistantUV, Scratch, and Chip Resistant
Reduces Dust Eco Friendly
Contains No Lead, No Zinc, No Chromates, No Acids and No Heavy Metals
No Topcoat NecessaryCompatible with Most Topcoat Paints
Weather Resistant in All Climates, Including CoastalService Temperature Range: up to 314°F continuously
and up to 662°F for 72 hour periods.Certified Mold EncapsulateSuperior Di-Electric StrengthNon-ConductiveFlame Spread Index of 0 & Smoke Developed Index of 5 Adds Years of Life to Concrete Surfaces
Red • Orange • Yellow • Green • Blue • Purple
Power wash or simply rinse off dirt and debris and let the surface dry completely before applying Rust Bullet. Two to three coats of Rust Bullet is usually sufficient for most concrete applications depending on the concrete’s condition and existing damage. Porous concrete and heavy traffic areas may require additional coats. Rust Bullet is self-leveling and can fill in cracks, gaps, and chips up to 1/8 inch. If a slip resistant surface is desired, sprinkle silica or similar fine sand over a tacky coat of Rust Bullet, allow
just enough time for the sand to adhere, and then apply the final coat of Rust Bullet.
Surface Cleaner & Conditioner
Cleanup, Thinning & Equipment Prep
DIY Application - Concrete Garage Floor
Rust Bullet Will Outperform Epoxy Coatings Open, Stir, Apply-No Messy Mixing
Recoat Time 6-24 Hours
Full Cure 72 hours
No Hot Tire Lifting
No Peeling or Flaking
Minimum Cure Tempurature at 35°F
No Acid Etching Required
No Grinding Required
No Yellowing
Chemical and Road Salt Resistant
Removed Existing Paint
Cleaned, Degreased and Rinsed
Filled cracks with sealer
Applied Rust Bullet for Concrete
Added Non-Skid for Slip Resistance
Cured for full 72 Hours
Rust Bullet not only improves the appearance of concrete, it provides an impervious shield allowing easy clean up of oil, grease, and chemical spills along with strong protection against impact and abrasives.
Simply Roll or Spray
High Performance, Chemical Resistant, Protective Topcoats
Rust Bullet WhiteShell, BlackShell, Clear Shot, and ColorShells were designed specifically as the optimum protective topcoats for the Rust Bullet Standard Concrete Coating, when a gloss colored finish is desired. Simply apply over the Rust Bullet Standard to create the strongest, chip resistant,
armor tough, protection against outside elements, with a beautiful gloss finish.
CoatingAccelerator
632 W Gunnison Ave. #C, Grand Junction CO 81501 USAToll Free: 800-956-4301 Fax: 888-473-5639 [email protected]
www.GarageFlooringLLC.com
Tested according to the American Society for Testing Materials (ASTM) Standards and the more stringent specifications of the United States Navy. For in-depth information
on these scientific tests, please visit our website www.RustBullet.com
Rust Bullet® No Topcoat
POR-15® SystemTopcoated with Napa
Ruf-Nek HD Spray Paint
Wasser® Brand System Rust-oleum® Cold Galvanizing
Compound
The picture to the left exhibits a metal panel coated in Rust Bullet Standard Formula that has been continuously soaking in Bio-diesel fuel since 2007. As you can see there is no coating degradation or loss of integrity.
The same in-house test was performed using brake fluid. Brake fluid is one of the most caustic automotive fluids that come into contact with concrete garage floors. Two weeks passed before the submerged coating began to wrinkle.
Rust Bullet was originally designed to resist the chemicals, fuels, UV light and severe abuse in the aviation industry.