INTERIOR

If you need more assistance, we are only a phone call away.

(770) 886-2500 Monday–Friday8:30am–5:30pm EST

GENO’S GARAGE, INC.1150 Samples Industrial DriveCumming, Georgia 30041

www.genosgarage.comInstallation:

‘13+ Ram Trucks

Getting StartedThe installation of this cup holder is easy. You’ll need a phillips head screwdriver (power tools are nice) and, optionally, a Dremel cut-off tool.

Installation

1. First, remove the plastic coverthat is over the factory three-cupholder. The cover is held on withexpandable push pins. Simply liftup to remove.

Removing plastic cover.

2. Test fi t the Geno’s ‘Double Cup’cup holder into place. Screw twophillips head screws (okay, use allfour?) into the plastic lip of thefactory console.

Test fi t the cup holder and then screw theself-tapping phillips head screws into place.

Continued on Next Page

‘Double Cup’ Cup Holder

INTERIORwww.genosgarage.comInstallation:

3. This step may be optional dependingon your success with Step 4, thereattachment of the factory plasticcover. If the plastic cover will attachand stay in place you can skip this step.

Here are the directions:

Remove the cup holder fromits test fi t location.

Notice where the cover meets theedge of the Geno’s Double Cupcup holder.

Apply masking tape.

Use masking tape to “draw” a straightline on the cover. Cut approximately1/8” off of the lip of the cover.

Then cut the edge with a Dremel tool.

4. Reinstall the cupholder and thenreattach the factory plastic cover.Hit the cover with your fi st to pushthe pins into the console sockets.

Reattach the cover and you are fi nished withthe installation of the ‘Double Cup’ cup holder.

‘Double Cup’ Cup HolderPAGE 2