Download - LYRASIS Mammoth materials unit3
Mammoth MaterialsHow to Preserve Posters,
Maps & Drawings
LYRASIS Preservation Services
Funded in part by a grant from the National Endowment for the
Humanities, Division of Preservation and Access
Unit 3
Unit 3• Storage basics• Supply terminology• Flat vs. rolled storage• General rules for oversized storage
Storage Basics• Identifying our oversized materials helps
us to figure out how to store them.• These storage basics will apply not only
to oversized materials, but mixed media collections.
Storage Basics• Controlling temperature & humidity is the
single most cost-effective action we can take to impact every item in the collection. When dealing with a variety of types of media, a good range to aim for is:– 68 – 72 degrees F– 40 – 50% RH
• Good air circulation is important to help prevent mold.
• Avoid basement or attic storage- temperature and humidity are too hard to control in these areas.
Storage Basics• Avoid direct sunlight--sunlight contains
harmful ultraviolet rays and also often increases temperature. Reducing direct exposure is especially important for any oversized material that is susceptible to fading.
• Store oversized materials in Flat File Cabinets or rolled storage. This should be at least 4 inches off the floor to prevent water damage, mop splashes, or damage from foot or cart damage.
Terminology for Supplies• Archival quality• Acid-free• Lignin and lig-free• Alkaline buffered• Photo-safe
Terminology for Supplies• Archival Quality
– This term does not have a meaning in and of itself. It alone does not represent a measurable standard. Do not rely on this phrase alone to indicate a product is appropriate to use.
Terminology for Supplies• Acid-free
– This indicates that when made, the product was tested for pH level of acidity – alkalinity and was found to be neutral or slightly alkaline.
– Acid-free is paper, folders and boxes are recommended for the storage of archival and library materials.
Terminology for Supplies• Lignin and lig-free
– Lignin is a natural component of trees. It allows for the break down of the wood after the tree has died. Desirable in nature, not in products made from wood.
– Look for products that are lignin free. This may not indicate zero lignin, but indicates very low levels based on industry standards.
Terminology for Supplies• Alkaline buffered
– May also see the term “buffered,” this indicates an alkaline reserve in the paper or box that will slow the acid deterioration inherent in some paper and printing processes.
– Buffered paper and boxes are not always the best choice. They can actually damage some printing processes. That will be discussed in upcoming slides.
Terminology for Supplies• Photo-safe
– This is a phrase that does not indicate any specific standards.
The phrase to look for is that the product has “Passed the Photographic Activity Test (PAT).” This means that the product will not react negatively with photographic processes or emulsion layers of photographic prints.
Size Matters• In a perfect world, Oversized items should
be stored flat – however, for really large items, rolling may be your only option.
• A good rule of thumb—if something is larger than 15 x 9 inches – the size of a standard legal document box—it should be stored flat.
Size Matters• Archival boxes made out of the same materials as
document boxes (i.e. blue-grey board or sometimes tan board), are great for items under 30 x 40 inches – they come in a variety of sizes. Depths are anywhere between 1 ½ in & 3 inch widths. Store them flat on shelves, as you see below.
Size Matters• For anything larger than 30 x 40 inches, items
should be stored in flat file cabinets. New flat files should be powder-coated and heat cured steel. Avoid wood or damaging metals files. If that’s all you have then line drawers with an inert barrier such as Polyester sheet.
• Always get the “riser” which will elevate your materials off the ground – away from water and feet.
Flat File CabinetsDO• Do use file drawer
composed of baked enamel with solvent free powder coating of polymers
• Do plan for expansion – leave a spare drawer in each case and room in each drawer
• Do remove folders from drawers one at a time
DO NOT• Do not fill drawers more
than 2 inches high or overcrowd folders
• Do not fold maps to fit folder or drawer sizes
• Do not label items or folders with ink – use only graphite pencil
• Do not use wooden shelving without appropriate barriers
Rolled Storage• There is the ideal and the
realistic. Some of us have so many rolled items that unrolling everything is not an option. Flat files are expensive and take up lots of space. Prioritize by importance, use, etc.
• Also, if your oversized material is large enough, it may not fit in your flat file.
Proper Rolled Storage• Roll on OUTSIDE of acid-free tube that is
at least 6 inches in diameter.• Use tubes that are longer than edges of
the materials being rolled.• Wrap with acid-free tissue, either
buffered or unbuffered depending on the type of process.– More discussion of this in a few more slides.
• Tie with plain cotton twill tape to secure.
Proper Rolled Storage• If something is heavily used,
wrapping it with paper may not make a lot of sense, because you’ll spend a lot of time wrapping and unwrapping. Instead, it might be better to encapsulate that item to protect it from dust, and then acid-free paper will not be needed.
Properly Rolled Storage ?
What’s going on here? Do you see any potential problems with how these items are rolled?
Properly Rolled Storage ?
• Textile looks ok but could use covering. If it is important to see the textiles, wrap them in clear mylar sheeting instead of paper
• Others look like they are rolled to tightly- would be better on the outside of the tube.
Telescoping Containers
Instead of wrapping the outside, another option is the square long tubes often described as telescoping containers. They are typically made of same material as document boxes. Be certain the box is long enough for the item is contains. There may be wear if you need to slide the rolled item out frequently.
Folders• Folders should meet Z39.48 (2002)
standard for permanent paper– Alkaline buffered or unbuffered– .10 point for small maps– .20 point or thicker for larger formats
or fragile materials• Folder dimensions should be
slightly larger than the objects• Folders should fit into drawers or
boxes without folding or bending
Oversize Folders• Can purchase from reputable vendor
– See Lyrasis vendor pageshttp://www.lyrasis.org/Preservation/Search-For-Vendors.aspx
• To make your own:− 10 or 20 pt board (comes in 30x40 and 60x40 inch
sizes)− Tyvek tape (spun polyester with a pH neutral acrylic
adhesive)
Fold board in half or cut board to correct size and make hinge with Tyvek tape
Buffered or Unbuffered?Buffered Paper/Board• Stencil Reproductions• Gel-Lithographs• Electrostatic• Manuscript Maps• Printed and
handcolored Maps• Full-Color Printed
Posters• Art on Paper• Posters
Unbuffered Paper/Board• Hectographs• Van Dyke Prints• Diazo & Sepia Diazo
Prints• Blueprints• Positive Blueprints/
Pellet Prints• Photostats• Ferrogallic Prints• Aniline Prints
Buffered or Unbuffered?
When in doubt, choose unbuffered folder, board, and boxes.
General Rules of Oversized Storage
• Store like items together: Printed maps on paper together, Blue prints together, Photo processes together, etc. Do not to mix the various types within the same folder, some print types are harmful to others. If not possible, isolate problematic types using polyester sleeves.
General Rules of Oversized Storage
• Polyester can be used with all of these EXCEPT Electrostatic (xeroxograpy, photocopy) or Pastel artwork. Plastic can lift off toner or other friable media (pastel, charcoal).
• Folder by processes, not by size – opposite of the rules for photographs
• Separate by process type within a folder using paper dividers (acid-free) alkaline buffered for most items.
General Rules of Oversized Storage
• Know which processes are sensitive to alkaline buffered paper and board products If you don’t want to buy two different types of boxes, folders, use Polyester sheets (or sleeves) for items that are sensitive to alkaline environments =e.g. blueprints.
• Unroll items only if the substrate is in good condition and you have a place to store it.
Section 3 Quiz
What did you learn?
Section 3 QuizQuestion 1:• Materials handling best practices
suggest that items of like size should be stored together.–True or False?
Section 3 QuizQuestion 1:• Materials handling best practices
suggest that items of like size should be stored together.–True or False?
Answer : TrueThis practice reduces the “wear” of edges against each other within a folder or drawer.
Section 3 QuizQuestion 2:• The best way to store an oversized
item on a roll is to roll it around an acid free core that is at least 6” larger than the item, cover the rolled object with a paper or inert plastic sheet and tie it with cotton tape.–True or False?
Section 3 QuizQuestion 2:• The best way to store an oversized item on
a roll is to roll it around an acid free core that is at least 6” larger than the item, cover the rolled object with a paper or inert plastic sheet and tie it with cotton tape.– True or False?
Answer : TrueThis is the suggested best practice.
Section 3 QuizQuestion 3:• It is recommended that a flat storage case
should be put on a riser. Why?
– A. to protect lower drawers from water on the floor
– B. To protect lower drawers from feet.– C. For ease of access. – D. All of the above.
Section 3 QuizQuestion 3:• It is recommended that a flat storage case
should be put on a riser. Why?
– A. to protect lower drawers from water on the floor
– B. To protect lower drawers from feet.– C. For ease of access. – D. All of the above.
Answer : D. All of the aboveThis is the suggested best practice.
Thank You!To continue Mammoth
Materials, View Unit 4
Contact us if you have any questions.
LYRASIS Preservation [email protected]
1-800-999-8558