Magnetic Connector Series
Features Benefi ts
Magnetic mating mechanismAids blind-mate performance and prevents inadvertent damage if the user forgets to unmate
Non-keyed rotatable matingDoes not require pre-alignment when mating. Cable exit angle is infi nitely variable and can be set and adjusted by the user
Wipe clean interface featuring sprung-loaded contacts
Easy cleaning and decontamination
5000+ mating cycles Increased connector life before replacement
Compatible with USB 2.0, Ethernet and Audio signal requirements
Allows interconnection of various equipment including computers, radios and headsets
Last mate contactAllows hot-swapping of equipment and signals(i.e. interface is passive until the connector is fully mated)
90° Cable exit within the height of the connector
Cable runs parallel to the body eliminating loops and preventing snagging
IP68 sealed High degree of sealing prevents ingress of dust and moisture
This series offers low profi le, compact, sealed connectors that withstand exposure to rain, dust, dirt and chemicals. Stingray connectors are intended for First Responders, Security and Military personnel.
Stingray features a magnetic, non-keyed mating system which allows the connector to be easily mated without the need for pre-alignment and eliminates the need to operate any coupling mechanisms.
Stingray has been optimised for USB 2.0 & Ethernet protocols, and is an excellent solution for audio, power or data signals.
The low profi le Stingray connector sits fl at against the body to prevent snagging & damage. It is self-aligning due to the strong magnetic connection, and allows customisation and fl exibility of cable routing as the cable can be rotated through 360o when the connector is mated.
Magnetic Connector Series
2 STINGRAY SERIES
Electrical
Current rating 3A per contact continuous, 5A per contact peak
Data rate USB 2.0 compliant
Insulation resistance 5000 MΩ at 500 VDC
Contact resistance <20 mΩ
Environmental
Sealing IP68, 1hr at 2 meters immersion
Operating temperature range -55oC/+85oC
Storage temperature range -55oC/+125oC
Salt spray 500 hours, 5% NaCl (mated)
RoHS compliant Yes (dependent on solder used)
Mechanical
Mating durability 5000 minimum
Shock and vibrationIn accordance with DEF-STAN 00-35 Iss 4 Ch2 01 test M1 appendix A fi gs A22-High Level and A23-Low Level
Separation force, peel 4.0N typical
Rotations 1000 minimum
Rotational torque 0.7Nm typical
Test parameter Description
Stingray features and terminology
Stingray performance information
Views of the mated pair
Sprung contactsInterfacial seal
‘Last-mate, fi rst-break’ contact
22 m
m
Non-keyed, rotatable interface
Flexible overmould
STINGRAY SERIES 3
Stingray connector part numbering
Stingray part number example
Stingray cable harness part numbering
Stingray cable harness part number example
Please note:The unplated wall mount receptacle in shell size 3 with 9 contacts is currently available.The plug connector is only currently available as an overmoulded cable harness.Further variants are available to order from December 2018.
Series identifi er Style:00 = Wall mount receptacle01 = In-line receptacle02 = PCB mount receptacle06 = Plug
Material and fi nishAU - unplated black thermoplastic
Shell size03
No. of contacts09
Variant (omitted for standard item)Consult factory for more details
WM- XX XX XX- XX- XXX
20GB-WM- XX XX XX- XX- XXXX- XXXXSeries identifi er Style:
00 = Wall mount receptacle02 = In-line receptacle06 = Plug
Material and fi nish:AU - Unplated Black Thermoplastic
Shell size:03
No. of contacts:09
Length (mm):
Variant:0001 = Pig-tail assembly0002 = Plug to Plug
Please note:Both the -0001 and -0002 variants use USB 3.0 SuperSpeed cable with high quality improved shielding. The cable is UL20276, OD:5.5mm with black PVC jacket.
Stingray Series
Wall mount receptacle
9 contacts
Shell size 03
Stingray Series
Unplated black thermoplastic
WM- 00 AU 03- 09
Stingray Series
Plug Length: 1m
Unplated black thermoplastic 9 contacts
Pig-tail assembly
Shell size 03
20GB-WM- 06 AU 03- 09- 1000- 0001
4 STINGRAY SERIES
Stingray plug assembly
Stingray plug wiring schematic
Please note:The plug is currently only available as an overmoulded cable harness.A customer terminated plug is available to order from December 2018.
Shell size
A Nom B Nom øC Nom D Nom E Nom
mm inch mm inch mm inch mm inch mm inch
3 11.99 0.472 59.82 2.355 38.35 1.510 10.41 0.410 12.45 0.490
Contact number
1
2
3
4
5
6
7
8
9
USB identifi cation USB 2.0 connection Cable colour
Power Yes Red
D- Yes White
D+ Yes Green
SDP1- No Blue
SDP1+ No Yellow
SDP2- No Purple
SDP2+ No Orange
Power GND Yes Black
GND drain Yes Drain
STINGRAY SERIES 5
Stingray receptacle
Stingray receptacle wiring schematic
Shell size
A Nom B Nom øC Nom D Nom E Nom
mm inch mm inch mm inch mm inch mm inch
3
12.52 0.493 52.96 2.085 39.88 1.570 39.88 1.570 33.02 1.300
øF Nom G Nom H Nom J Nom K Nommm inch mm inch mm inch mm inch mm inch
3.18 0.125 6.32 0.249 14.99 0.590 10.67 0.420 13.08 0.515
Contact number
1
2
3
4
5
6
7
8
9
USB identifi cation USB 2.0 connection
Power Yes
D- Yes
D+ Yes
SDP1- No
SDP1+ No
SDP2- No
SDP2+ No
Power GND Yes
GND drain Yes
Please note:An alternative PCB mount receptacle (WM-02) is available to order from December 2018
6 STINGRAY SERIES
Stingray receptacle assembly instructions
General assembly instructions are shown below for the Stingray receptacle connector. The receptacle is supplied as three components ready for termination as shown below:
1. Terminate the cable to the PCB sub-assembly in accordance with Amphenol document 123GB-0879.2. Lightly press the terminated PCB sub-assembly into the top housing.3. Locate the back plate into the top housing (trapping the terminated PCB sub-assembly) and
evenly apply pressure from the rear so that the clips fully engage and ‘snap’ into position.
Please note that ancillary components have been deleted from the above image for clarity.
Top housing
PCB sub-assembly
Back plate
STINGRAY SERIES 7
For more information call +44 (0)1227 773200Amphenol Ltd Thanet Way Whitstable Kent CT5 3JF | Email: [email protected] | www.amphenol.co.uk
Amphenol Ltd, UKThanet Way, WhitstableKent, CT5 3JFUnited KingdomT: +44 1227 773 200
Amphenol Socapex, France948, promenade de l’Arve BP29 74311 Thyez CedexFranceT: +33 4 50 89 28 00
Amphenol Air LB, France10 rue champ Raymond08110 CarignanFranceT: +33 3 24 22 32 70
Amphenol AIR LB GmbH, GermanyAm Kleinbahnhof 466740 SaarlouisGermanyT: +49 6831 981 00
Amphenol NordicT: +46 (0)702 3800104Amphenol Switzerland and South CentreSwitzerland, Slovenia, Serbia, Montenegro,Yugoslavia, Greece, Bulgaria948, promenade de l’Arve BP2974311 Thyez CedexFranceT: +33 4 50 89 28 00
Amphenol ItalyVia Barbaiana n.520020 Lainate, MilanoItalyT: +39 293 254 214
Amphenol BeneluxZadelmaker 121 NL2401 PD Alphen aan den RijnThe NetherlandsT: +31 172 444 903
Amphenol IbericaEdificio Burgosol, Oficina nr 55 Comunidad de Madrid, 35 bis Las Rozas (Madrid)SpainT: +34 91 640 73 06
Amphenol Poland and Central East EuropeAustria, Poland, Czech Republic, Slovakia, RomaniaWiener gasse 682380 Perchtoldsdorf AustriaT: +43 699 10396 071
Europe
Amphenol Daeshin, Korea558 SongNae-2 Dong, SoSa-Gu, Bucheon City, Gyeonggi-do422-040, KoreaT: +82 32 610 3800
Amphenol Interconnect India Private Limited105 Bhosari Industrial AreaPune 411 026IndiaT: +91 203 068 8304
Amphenol Japan471-1 Deba, Ritto-CityShiga 520-3041JapanT: +81 77 553 8501
Amphenol PCD CO Ltd, ChinaBuilding 21, 1st Liao Keng Industrial Zone, Shi Yan Street Bao An District, Shenzhen 518108ChinaT: +86 755 8173 8000
Asia
Amphenol PCD USA72 Cherry Hill DriveBeverly, MA. 01915-1065USAT: +1 978 624 3400
Amphenol Canada Corporation605 Milner AvenueToronto, OntarioCanadaM1B 5X6T: +1 416 291 4401
North America
Amphenol ArgentinaAv. Callao 930 2do piso Oficina B “Plaza” C1023 – AAP, Buenos AiresArgentinaT: +54 11 4815 6886
Amphenol Australia Pty Limited22 Industry BoulevardCarrum Downs, Victoria 3201AustraliaT: +61 8796 8888
Amphenol Do BrazilRua Diogo Moreira132, 20 andar, rooms 2001-2-3CEP: 05423 010 Sao Paulo SPBrazilT: +55 11 3815 1003
Amphenol Bar-Tec Ltd, Israel3 Hagavish Street, K fir-Barkan BldgEast Industrial ZoneKfar-Sava, 44102IsraelT: +972 9 764 4100
Amphenol MexicoProlongacion Reforma 61-6 B2Col Passo de las Lomas CP.013130MexicoT: +52 55 5258 9984
Amphenol RussiaYaroslavskaja Street 8129164 MoscowRussiaT: +7 495 937 6341
Amphenol South Africa30 Impala Road2196 ChislehurstonSandtonSouth AfricaT: +27 11 783 9517
Amphenol TurkeySun Plaza 15 Kat:15 Maslak Hah. BilimSok. No.5Sisli/Istanbul, 34398TurkeyT: +90 212 367 92 19
Other areas
Worldwide sales contacts
May 2018