Download - Sachin George
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 1/12
DESIGN OF A FLYBACK CONVERTER FORIMPROVED CONVERSION EFFICIENCY AND
REDUCED NO-LOAD POWER LOSS.
Sachin George Thomas
Applied Electronics and Instrumentation
College of Engineering Trivandrum
Guided By : Ms. Chandini G.S.
October 30, 2015
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 2/12
Overview
Introduction
Motivation
Problem Definition
Methodology
References
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 3/12
Introduction
Most of the portable products in our lives are powered by d.cvoltage and ac-dc adapters are used for conversion from theac voltage to the required dc voltage.
The ac-dc adapter is composed of a rectifier, a dc buscapacitor and a dc-dc converter.
The dc-dc converter can be of the isolated type whichincludes flyback converters and forward converters or thenon-isolated type .
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 4/12
Introduction
The flyback convertor which comes under the category of isolated converter is of particular interest in this work.
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 5/12
Motivation
Compared to the flyback converters , the forward convertersrequires a reset winding , an output inductor and a free
wheeling diode which causes larger volume and more cost.
Even the conventional flyback converters suffers from lowconversion efficiency and high no-load power loss.
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 6/12
MOTIVATION
Furthermore , the parasitic capacitance of the transformerbetween the primary and secondary windings needs to bereduced inorder to keep the common voltage under control.
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 7/12
Problem Definition
Requirement for a flyback converter with improved conversionefficiency, reduced no-load power loss , and a power factorcorrection circuitry.
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 8/12
Methodology
Design of the lossless snubber circuit for suppressing thevoltage spikes
fig : Flyback convertor with RCD snubber
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 9/12
Methodology
Design of the energy recovery winding to recycle the energy
discharged from the gate -source capacitor of the main switch.
Check for the feasibility of a Power Factor Correction (PFC)circuitry and if possible integrating the same.
Integration of all the circuits .The simulation can be carriedout in SIMULINK/SIMPLIS.
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 11/12
References
Ray-Lee Lin and Shih-Ho Hsu , ”Design andImplementation of Self-Oscillating Flyback Converter
With Efficiency Enhancement Mechanisms” IEEETransactons on Industrial Electronics,Volume 62,Issue11,pages 6964-6955,November 2015
J.Y.Guo, ”Design and implementation of forward-flyback
converter with feed forward mechanism for mobile
phone”M.S thesis,National Cheng Kung University,May 2013
Hao Ma , Yue Ji and Ye Xu, ”Design and Analysis of
Single-Stage Power Factor Correction Converter With a
Feedback Winding” IEEE Transactons on PowerElectronics,Volume 25,Issue 6,pages 1460-1471,June 2010
7/24/2019 Sachin George
http://slidepdf.com/reader/full/sachin-george 12/12
The End